Cisco RV016 User Manual page 18
10/100 16-port vpn router business series
Hide thumbs
Also See for RV016:
- Administration manual (199 pages) ,
- Quick start manual (13 pages) ,
- Datasheet (4 pages)
Table of Contents
Advertisement
Chapter 4
Add One More Class C Network
If you want to modify a subnet you have created, select
it and make changes. Click Save Settings to save your
changes, or click Cancel Changes to undo them. Click
Exit to return to the Network screen.
If you want to delete a subnet you have created, select it
and click Delete selected subnet. Click Save Settings
to save your changes, or click Cancel Changes to undo
them. Click Exit to return to the Network screen.
You can also divide a Class C network into four subnets.
For example, the current LAN settings show the Device
IP Address as 192.168.1.1 and the Subnet Mask as
255.255.255.192.
LAN Settings Example
To get the other three subnets, enter the following:
Subnet 1
LAN IP Address
192.168.2.65
•
Subnet Mask
255.255.255.192
•
Subnet 2
LAN IP Address
192.168.2.129
•
Subnet Mask
255.255.255.192
•
Subnet 3
LAN IP Address
192.168.2.193
•
Subnet Mask
255.255.255.192
•
Click Add to List. Then click Save Settings.
10/100 16-Port VPN Router
Advanced Configuration
Create Three Additional Subnets
WAN Setting
By default, the Router allows you to simultaneously
connect two broadband connections to the Router;
however, you can set up as many as seven broadband
connections.
From the drop-down menu, select how many WAN ports
you want to use. The default is 2. (You can also change
the number of WAN ports using the Port Management
> Port Setup screen.) Make sure the physical network
configuration matches the number of WAN port settings
on this screen.
If you change the number of WAN ports, click Save
Settings to save your change. A confirmation message
will appear. Then click OK to save the new setting.
The WAN Setting table displays the WAN port numbers
in the Interface column and their respective connection
types in the Connection Type column. Click Edit in the
Config. column to change the WAN settings of the selected
WAN port. You must save the new number of WAN ports
before you can click Edit to change the settings of any
new WAN ports.
The Connection Type column will display the word
"Undefined" if you changed the number of WAN ports
but did not click Save Settings. After you save this setting,
the Connection Type column will display, "Obtain an IP
automatically. " The default Connection Type of all WAN
ports is Obtain an IP automatically.
Edit WAN Connection
After you clicked Edit, configure the WAN settings for the
selected WAN port.
Interface
The selected WAN port will be displayed.
11
Hide quick links:
Advertisement
Table of Contents
