Advertisement
Quick Links
Upper Receiver Replacement Kit
Greensmaster
Mower
Model No. 147-2288
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
1
Preparing the Machine
No Parts Required
For Gas Machines
1.
Park the machine on a level surface.
2.
Shut off the machine.
3.
Remove the spark-plug wire from the spark plug;
refer to your machine Operator's Manual.
© 2023—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
1018, Flex 1018, 1021, e1021, Flex 1021, or 1026
Description
No parts required
No parts required
No parts required
Latch bolt
Nut
Upper receiver weldment
No parts required
Clevis pin
Yoke pin
Cotter pin
No parts required
Register at www.Toro.com.
Qty.
–
Prepare the machine.
–
Remove the control cover.
–
Remove the upper receiver weldment.
1
Install the latch bolt.
1
1
Install the upper receiver weldment.
–
Adjust the latch bolt.
1
1
Install the handle assembly.
2
–
Install the control cover.
For Battery-Powered Machines
1.
Park the machine on a level surface.
2.
Shut off the machine and remove the key.
3.
Disconnect the battery; refer to your machine
Operator's Manual.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3462-797 Rev A
Installation Instructions
Use
*3462-797*
Advertisement
Related Manuals for Toro 147-2288
Summary of Contents for Toro 147-2288
- Page 1 Form No. 3462-797 Rev A Upper Receiver Replacement Kit Greensmaster ® 1018, Flex 1018, 1021, e1021, Flex 1021, or 1026 Mower Model No. 147-2288 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty.
- Page 2 Removing the Control Cover No Parts Required Procedure Disconnect the wire-harness connector from the hour meter (Figure g280734 Figure 2 1. Screw 2. Control cover Removing the Upper Receiver Weldment g280735 Figure 1 1. Wire-harness connector 2. Hour meter No Parts Required Remove the control cover by removing the Procedure screws that secure the control cover to the rear...
- Page 3 Installing the Latch Bolt Installing the Upper Receiver Weldment Parts needed for this procedure: Latch bolt Parts needed for this procedure: Upper receiver weldment Procedure Procedure Remove the hardware that secures the Install the upper receiver weldment onto the handle handle-height adjuster to the old upper receiver tube.
- Page 4 Adjusting the Latch Bolt No Parts Required Procedure • If the handle-height adjuster is parallel with the handle tube while the bolt is in the neutral position, proceed to 7 Installing the Handle Assembly (page • If the handle-height adjuster is not parallel with the handle tube while the bolt is in the neutral position, perform the following steps: Loosen the nut on the latch bolt so that the bolt...
- Page 5 Installing the Handle Installing the Control Cover Assembly No Parts Required Parts needed for this procedure: Procedure Clevis pin Refer to the illustrations in 2 Removing the Control Yoke pin Cover (page 2) for this procedure. Cotter pin Use the previously removed screws to install the control cover.
- Page 6 Notes:...
- Page 7 Notes:...