Cisco Firepower 2100 Getting Started Manual page 86
Hide thumbs
Also See for Firepower 2100:
- Getting started manual (222 pages) ,
- Manual (44 pages) ,
- Getting started manual (104 pages)
Table of Contents
Advertisement
Configure NAT
Step 5
Click Save.
Configure NAT
Configure NAT
A typical NAT rule converts internal addresses to a port on the outside interface IP address. This type of NAT
rule is called interface Port Address Translation (PAT).
Procedure
Step 1
Choose Devices > NAT, and click New Policy > Threat Defense NAT.
Step 2
Name the policy, select the device(s) that you want to use the policy, and click Save.
Figure 60: New Policy
The policy is added the management center. You still have to add rules to the policy.
Cisco Firepower 2100 Getting Started Guide
84
Threat Defense Deployment with a Remote Management Center
Advertisement
Chapters
Table of Contents
