Cisco Firepower 2100 Getting Started Manual page 159
Hide thumbs
Also See for Firepower 2100:
- Getting started manual (222 pages) ,
- Getting started manual (150 pages) ,
- Getting started manual (104 pages)
Table of Contents
Advertisement
Threat Defense Deployment with CDO
Procedure
Step 1
Choose Devices > Device Management, and click Edit ( ) for the device.
Step 2
Choose DHCP > DHCP Server.
Figure 107: DHCP Server
Step 3
On the Server page, click Add, and configure the following options:
Figure 108: Add Server
• Interface—Choose the interface from the drop-down list.
• Address Pool—Set the range of IP addresses from lowest to highest that are used by the DHCP server.
The range of IP addresses must be on the same subnet as the selected interface and cannot include the
IP address of the interface itself.
• Enable DHCP Server—Enable the DHCP server on the selected interface.
Step 4
Click OK.
Configure the DHCP Server
Cisco Firepower 2100 Getting Started Guide
157
Advertisement
Chapters
Table of Contents
