Removing The M.2 2280 Solid-State Drive From Slot 0 - Dell OptiPlex Micro Plus 7020 Owner's Manual
Hide thumbs
Also See for OptiPlex Micro Plus 7020:
- Owner's manual (140 pages) ,
- Owner's manual (159 pages)
Table of Contents
Advertisement
Figure 22. Installing the M.2 2230 solid-state drive in slot 1
Steps
1. Align the notch on the M.2 2230 solid-state drive with the tab on the solid-state drive slot 1 (M.2 PCIe SSD 1).
2. Slide the M.2 2230 solid-state drive into the solid-state drive slot 1 (M.2 PCIe SSD 1) on the system board.
3. Replace the screw (M2x3.5) that secures the M.2 2230 solid-state drive to the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Removing the M.2 2280 solid-state drive from slot 0
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the speaker.
About this task
NOTE:
Depending on the configuration ordered, your computer may have an M.2 2230 or an M.2 2280 solid-state drive
that is installed in solid-state drive slot 0 (M.2 PCIe SSD 0).
NOTE:
This procedure is applicable for computers where an M.2 2280 solid-state drive is installed in solid-state drive slot 0
(M.2 PCIe SSD 0).
The following image(s) indicate the location of the M.2 2280 solid-state drive in slot 0 and provides a visual representation of
the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs)
45
Hide quick links:
Advertisement
Table of Contents
