Table of Contents
Advertisement
Replacing a Fan Module During Operations
1
Press inward on both colored slides of the handle.
b) Place the removed module on an antistatic surface or in an antistatic bag. If possible, repack the module in its packing
materials for safe shipping or storage.
Step 2
Follow these steps to replace the missing fan module within two minutes to avoid a shutdown.
a) Remove the replacement fan module from its packing materials and place it on an antistatic surface.
Hold the module by its handle and do not touch the electrical connectors on its backside. Also, to protect the electrical
connectors, avoid letting them come in contact with anything other than the electrical connectors inside the chassis.
b) Verify that you have the right fan module for the chassis. The correct fan module has one of the following part
numbers:
• NXASFAN-160CFM-2PE (port-side exhaust airflow direction and a blue stripe)
• NXASFAN-160CFM-2PI (port-side intake airflow direction and a red stripe)
Note
c) Position the fan module in front of the open fan slot (be sure that the backside of the module with the electrical
connectors is positioned to enter the slot first) and slide the module all the way into the chassis until its front side
comes in contact with the chassis. For the last 0.2 inches (0.5 cm), carefully mount the module onto the chassis
connectors by pushing more firmly, but do not force the module if it does not move further (excessive force can
damage the connectors).
Note
d) Verify that the STS LED turns on and becomes green.
Cisco Nexus 9364C-H1 NX-OS Mode Switch Hardware Installation Guide
34
Be sure that the airflow direction of the new fan module matches the airflow direction of the other fan
and AC power supply modules already installed in the chassis. Port-side intake airflow is indicated with
red coloring, and port-side exhaust airflow is indicated with blue coloring. Power supplies with
dual-direction airflow (airflow direction is set by the fan modules) have white coloring.
If you are not able to push the module all the way into the slot, carefully slide the module out of the slot
and check its electrical connectors for damage. If damaged, contact Cisco Technical Assistance for help.
If undamaged, repeat this step to reinstall the module.
2
While holding the sides inward, pull on the handle
to remove the module from the chassis.
Replacing Components
Advertisement
Chapters
Table of Contents
