Table of Contents
Advertisement
The anti-crease phase starts, the
indicator
is blinking, and the Start /
Pause
led remains lit. The drum
performs smooth movements for about
30 minutes to keep the steam benefit.
To interrupt the anti-crease phase, you
can:
• Press the On/Off button for a few
seconds to activate or the deactivate
the appliance.
• Turning the programme dial in
another position.
When the anti-crease movements stop
and the door unlocks, the appliance
proposes again the previous set
programme.
A small laundry load helps to
reach better results.
7.7 Extra Rinse
With this option you can add a few rinses
to the selected washing programmes and
optimise the fabric softener distribution
and improve the fabric softness.
It is suggested when you use the fabric
softener.
Useful for people allergic to detergents
and in areas where the water is soft.
This option increases the programme
duration.
The button indicator comes on.
7.8 Time Save
With this option you can decrease the
programme duration.
• If your laundry is normally or lightly
soiled, it may be advisable to shorten
the washing programme. Touch this
button once to decrease the duration.
• In case of smaller load, touch this
button twice to set an extra quick
programme.
In this case, the temperature 95°C is
not selectable.
The led of the button is on and the
display shows the set programme
duration.
This option can also be used
to shorten the steam
programme duration.
7.9 Stains/Prewash
Press this button repeatedly to activate
one of the two options or both.
The relevant indicator goes on in the
display.
• Stains
Select this option to add an anti-stain
phase to a programme in order to
treat heavily soiled or stained laundry
with stain remover.
Pour the stain remover into
compartment
. The stain remover
will be added in the appropriate phase
of the washing programme.
This option is not
available with a
temperature lower than
40 °C.
• Prewash
Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust , mud and other
solid particles.
The options can increase the
programme duration.
7.10 Spin
When you set a programme, the
appliance automatically selects the
default spin speed.
Touch this button repeatedly to:
• Change the spin speed.
The display shows only
the spin speeds available
for the set programme.
• Activate the Rinse Hold option .
The water of the last rinse is not
drained out to prevent the fabrics from
creasing. The washing programme
ends with water in the drum and the
final spin phase is not performed.
ENGLISH
17
Advertisement
Table of Contents
