9. BEFORE FIRST USE..................21 10. PROGRAMMES....................21 WI-FI - CONNECTIVITY SETUP..............27 12. DAILY USE....................... 29 13. HINTS AND TIPS....................35 14. CARE AND CLEANING..................37 15. TROUBLESHOOTING..................43 16. CONSUMPTION VALUES................48 17. QUICK GUIDE....................50 18. ENVIRONMENTAL CONCERNS..............52 My AEG Care app...
ENGLISH FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
Page 4
Children between 3 and 8 years of age and persons • with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised. Children of less than 3 years of age should be kept •...
ENGLISH The appliance must be connected to the water mains • using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. Old hose sets must not be reused. • If the mains power supply cable is damaged, it must •...
Page 6
2.4 Use to a grounding connection in the building. • Always use a correctly installed WARNING! shockproof socket. Risk of injury, electric shock, • Make sure that the parameters on the fire, burns or damage to the rating plate are compatible with the appliance.
Ironing will be easier! • The UniversalDose drawer with a • The AEG Steam Fragrance, thanks compartment dedicated to each type to the steam programmes offers the of detergent, including a compartment perfect solution for refreshing even for PODS®, equipped with a system...
ENGLISH Level of protection against ingress of solid particles and IPX4 moisture ensured by the protective cover, except where the low voltage equipment has no protection against mois‐ ture Water supply pressure Minimum 0.5 bar (0.05 MPa) Maximum 10 bar (1.0 MPa) Cold water Water supply Maximum Load...
Page 10
5. Carefully put the appliance down on It is possible to see its rear side. water flowing from the 6. Put the front polystyrene packaging drain hose. This is due element on the floor under the to the testing with water appliance.
Page 11
If you install the appliance on a plinth adjust the level. that is not an accessory supplied by AEG, secure the appliance with the fixing plates. This spare part is available in web shop or from authorised dealer. Read carefully the instructions supplied with the accessory.
Page 12
You can extend the drain hose to maximum 400 cm. Contact the authorized service centre for the other drain hose and the extension. It is possible to connect the drain hose in different ways: 1. The drain hose can be bent into U...
Page 13
ENGLISH 6. Position the hose directly to a built- in drain pipe in the room wall and tighten it with a clamp. 5.7 Electrical connection The end of the drain hose must always be ventilated , At the end of installation you can connect i.e.
6. CONTROL PANEL 6.1 Control panel description Sport Home Special The options are not selectable with all washing programmes. Check the compatibility between options and washing programmes in the "Options compatibility with programmes" paragraph in the "Programmes" chapter. An option can exclude another one, in this case the appliance doesn't allow you to set the incompatible options together.
Page 15
ENGLISH 6.2 Display Door locked indicator. Washing phase indicator. It flashes during pre-wash and wash phase. Rinsing phase indicator. It flashes during rinse phase. Spinning and draining phase indicator. It flashes during spin and drain phase. Steam phase indicator. Anti-crease phase indicator. Eco programme indicator: it lights on when the selected programme and options have an eco profile.
Page 16
The digital indicator can show: • Programme duration (e. g. The time shown when the programme is set could not correspond to effective duration and change af‐ ter ProSense phase. • Maximum load. • Finish in time (e. g.
ENGLISH 7. DIAL AND BUTTONS 7.4 Introduction 7.1 On/Off Pressing this button for a few seconds The options/functions are allows to activate or deactivate the not selectable with all appliance. Two different tunes sound washing programmes. while switching the appliance on or off. Check the compatibility between options/functions As the Stand-by function automatically...
Page 18
This option allows choosing the time better penetrates the laundry if there is within which a programme should more space. For this reason, the terminate. The programme end can be programme maximum load combined postponed by one 1 hour every button with this option is 2 kg (approximately 8 - touch until 24 hours maximum.
Page 19
ENGLISH 7.11 Time Save These two options cannot be set together. With this option you can decrease the programme duration. 7.13 Spin • If your laundry is normally or lightly soiled, it may be advisable to shorten When you set a programme, the the washing programme.
Set Touch this button repeatedly until the this option for very delicate fabrics. desired temperature value appears on The rinses phase uses more water for the display. some washing programmes When the display shows the indicators...
10.1 My AEG Care app and additional hidden programmes My AEG Care app provides you with a wide choice of additional hidden programmes. Connect the appliance to My AEG Care and you will be able to choose the programme that suits your needs most.
Page 22
10.2 Programme Chart The programmes are described in this chart following the order of the selector dial from the top to the bottom. Washing programmes Programme Programme description Cotton and mixed synthetic fabrics. Ideal to wash your daily load in a short time, for a better clothes care and good cleaning MixLoad 69min already at 30°C.
Page 23
ENGLISH Programme Programme description Maintenance cycle with hot water to clean and freshen the drum and to remove residue that may cause odour. Before run‐ Machine Clean ning this cycle, remove all items from the drum. Pour a cup of chlorine bleach or a washing machine cleaner in the washing phase compartment of the detergent dispenser.
Page 24
Programme Default tempera‐ Reference spin Maximum load ture speed Temperature Spin speed range range 40 °C 1200 rpm 5.0 kg 60 °C - Cold 1200 rpm - 400 rpm Synthetics 30 °C 800 rpm 2.0 kg 40 °C - Cold...
Page 25
Its benefit would Fragrance) evaporate. • Use the fragrance with different The AEG Steam Fragrance allows you to purposes than those here described. refresh even your delicate clothes, • Use the fragrance on new garments. removing wrinkles and adding freshness...
Page 26
■ ■ ■ Extra Silent ■ No Spin ■ ■ ■ Stains ■ ■ Prewash ■ ■ ■ ■ Time Save Extra Rinse ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Plus Steam PODS® ■ ■ ■...
This chapter describes how to connect • Scan the QR code with the built-in the smart appliance to the Wi-Fi network camera app to download the My AEG and to link it to mobile devices. Care application from the App store...
Page 28
The access point will be open for about 3 read the next paragraph 'Configuring minutes. the appliance wireless connection'. 5. Configure the My AEG Care app on 4. Start the application. Select the your smart device and follow the country and language and login with instructions to connect the appliance Your email and password.
ENGLISH To remove the Remote Start, tap on the 11.4 Remote Start Remote Start button and confirm by The Remote Start enables you to start a pressing the Start/Pause button. cycle in remote control. 11.5 Over-the-air update The Remote Control activates automatically when The App may propose an update for your you press the Start/Pause...
Page 30
12.3 Filling the detergent and 3. Press the On/Off button for a few additives seconds to activate the appliance. A short tune sounds. The appliance automatically proposes a default programme. The relevant indicator illuminates. The display shows the cycle duration, the...
Page 31
ENGLISH After a washing cycle, if necessary, remove any detergent residue from the detergent dispenser. Proceed as follows 1. Open the detergent dispenser. 2. If a prewash phase is set, put the powder detergent in compartment 3. For main wash, chose the proper compartment depending on the type c) Put the tablets in the compartment of detergent:...
Page 32
To change or cancel this declared load for the set programme (only for a few seconds), the default option: temperature, the default spin speed and the washing phase indicators (when 1. Switch the appliance off by means of available).
Page 33
ENGLISH When the phase ends the relevant In case of in case of indicator stops flashing and is steady on. drum overload, the The next phase indicator starts flashing. maximum declared load indicator comes on again with the indicator E.g. the rinse phase is running: blinking.
Page 34
(if they are If the ProSense phase is active). already carried out and the water filling is already In the display all washing phase started, the new programme indicators become steady and the time starts without repeating the area shows .
ENGLISH • You do not use the appliance for 5 2. Touch the Start/Pause button: minutes before you touch the Start/ • If you have set , the appliance Pause button. drains the water and spins. Press the On/Off button to activate •...
Page 36
First, follow these generic rules: – powder detergents (also tablets and single-dose detergents) for all types of fabric, excluding delicate. Prefer powder detergents containing bleach for whites and laundry sanitization, – liquid detergents (also single-dose detergents) , preferably for low •...
ENGLISH • With adequate pre-treatment, stains use a water softener for washing and limited soiling can be removed; machines. the laundry can then be washed at a In areas where the water is soft it is not lower temperature. necessary to use a water softener. •...
Page 38
14.4 Descaling If the water in your area is hard or medium hard, we recommend that you use a water softener for washing machines. Regularly examine the drum to check for limescale. The regular detergents already contain Clean it when needed, using ammonia...
Page 39
ENGLISH Occasionally, at the end of a cycle the display may show the icon : this is a recommendation to perform the “drum cleaning”. Once the drum cleaning has been performed, the icon disappears. 14.8 Cleaning the detergent dispenser 4. Wash the detergent dispenser and To prevent possible deposits of dried any insert under running water.
Page 40
CLICK 7. Make sure that all detergent residue is removed from the conveyor. Use only soft damp clothes. 8. Put bottom cover back to its position 9. Reassembly the drawer as follows: by aligning its holes on drawer hooks a.
Page 41
ENGLISH • The appliance makes an unusual noise because of the blockage of the drain pump. • The display shows the alarm code WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot.
Page 42
1. Remove the inlet hose from the tap and clean the filter. 11. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages.
ENGLISH 14.12 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket.
Page 44
With some problems, the display shows an alarm code and the Start/Pause button may flash continuously: If the appliance is overloaded, remove some items from the drum and/or keep pressed the door while touching the Start/Pause button until the indicator stops flashing (see the picture below).
Page 45
ENGLISH • The programme was not finished properly or the appliance stopped too early. Switch the appliance off and on again. Internal fail. No com‐ • If the alarm code appears again, contact the Authorised Serv‐ munication between ice Centre. electronic elements of the appliance.
Page 46
Problem Possible solution • Make sure that a washing programme that ends with water in tub, has not been selected. • Make sure that the washing programme is finished. • Set the drain or the spin programme if there is water in the drum.
Page 47
ENGLISH Problem Possible solution • Make sure the levelling of the appliance is correct. Refer to The appliance makes "Installation instruction". an unusual noise and • Make sure that the packaging and/or the transit bolts are re‐ vibrates. moved. Refer to "Installation instruction". •...
Make sure that the water meanwhile, open the appliance door. level inside the drum is not too high. If necessary, proceed with an emergency drain (refer to «Emergency drain» in «Care and cleaning»...
Page 49
ENGLISH 16.3 According to Commission Regulation Eu 2019/2023 Eco 40-60 pro‐ Litres hh:mm °C gramme Full load 10.0 0.710 70.0 03:55 44.00 31.0 1600 Half load 0.520 52.0 02:59 44.00 29.0 1600 Quarter load 0.260 34.0 02:50 45.00 24.0 1600 1) Maximum spin speed.
Programme Litres hh:mm °C Wool 0.300 70.0 01:15 30.00 30.0 1200 30°C 1) Maximum spin speed. 2) Suitable for washing heavily soiled textiles. 3) Suitable for washing lightly soiled cottons, synthetic and mixed fabrics. 4) It also performs as quick washing cycle for lightly soiled laundry.
Page 51
ENGLISH Clean the filter regularly and, especially, if the alarm code appears on the display. 17.3 Programmes Programmes Load Product description Cotton and synthetic items. This programme ensures a good washing performance in a short time. The standard program duration has been de‐ 8.0 kg veloped on a laundry load of 5 kg.
Programmes Load Product description To spin the laundry and to drain the water in 10.0 kg the drum. All fabrics, except woollens and del‐ Spin/Drain icate fabrics. 1) Tested for Staphylococcus aureus, Enterococcus faecium, Candida albicans, Pseudomonas aerugino‐ sa and MS2 Bacteriophage in external test performed by Swissatest Testmaterialien AG in 2021 (Test Report No.
Page 56
My AEG Care app The software in this product contains components that are based on free and open source software. AEG gratefully acknowledges the contributions of the open software and robotics communities to the development project. To access the source code of these free and open source software components whose license conditions require publishing, and to see their full copyright information and applicable license terms, please visit: http://aeg.opensoftwarerepository.com (folder NIUS)