Table of Contents
Advertisement
Front brake master cylinder bleed screw
Brake caliper bleed screw
Front wheel axle pinch bolt
Rider footrest bolt
Passenger footrest bolt
Rear frame lower reinforcement bolt
Rear brake master cylinder bolt
Rear brake hose union bolt
Sidestand bracket bolt
Battery box bolt
Lean angle sensor bolt
Mudguard stay bolt
Mudguard bolt
Catalytic converter cover bolt
Lower ring nut
1. First, tighten the lower ring nut to approximately 52 Nm (5.2 m•kgf, 37 ft•lbf) with a torque wrench, then loosen the lower ring nut com-
pletely.
2. Retighten the lower ring nut to 18 Nm (1.8 m•kgf, 13 ft•lbf) with a torque wrench.
Front wheel axle pinch bolt
1. Insert the front wheel axle from the right side and tighten it with the flange bolt from the left side to 91 Nm (9.1 m•kgf, 66 ft•lbf) without
performing temporary tightening.
2. In the order pinch bolt (2) → pinch bolt (1) → pinch bolt (2), tighten each bolt to 21 Nm (2.1 m•kgf, 15 ft•lbf) without performing temporary
tightening.
3. Check that the right end of the front axle is flush with the front fork. If necessary, manually push the front axle or lightly tap it with a soft
hammer until its end is flush with the front fork. However, if the surface of the front axle end is not parallel to the surface of the front fork,
align a point on the outer edge of the axle with the fork, making sure that the axle does not protrude past the fork.
4. In the order pinch bolt (4) → pinch bolt (3) → pinch bolt (4), tighten each bolt to 21 Nm (2.1 m•kgf, 15 ft•lbf) without performing temporary
tightening.
Item
4 3
Thread size
M8
M8
M8
M8
M8
M6
M6
M10
M10
M6
M4
M6
M6
M6
2 1
-16-
Tightening torque
Nm
m•kgf
ft•lbf
6
0.6
4.3
5
0.5
3.6
See TIP.
28
2.8
20
28
2.8
20
13
1.3
9.4
13
1.3
9.4
30
3.0
22
63
6.3
45
7
0.7
5.1
2
0.2
1.4
7
0.7
5.1
10
1.0
7.2
7
0.7
5.1
Advertisement
Table of Contents
