Table of Contents
Advertisement
Install the Device
2. Insert the power supply cord into the tie [1, 3] and tighten the tie around the power supply cord as shown
in [2, 4] in the figure below.
Figure 19: Attach the AC Power Tie-and-Clip Cord
Note
Activate an AC Power Supply Module
Perform the following procedure to activate an AC power supply:
Step 1
Plug the power cord into the power supply.
Step 2
Connect the other end of the power cord to an AC-input power source.
Step 3
Verify power supply operation by checking if the respective power supply front panel LED (PS0 or PS1) is green.
Step 4
If the LEDs indicate a power problem, see Troubleshooting for troubleshooting information.
Step 5
If you are also connecting a redundant AC power supply, repeat these steps for the second power source.
Note
If you are connecting a redundant AC power supply, ensure that each power supply is connected to a separate
power source in order to prevent power loss in the event of a power failure.
These images are for only representation purposes.
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
Activate an AC Power Supply Module
39
Advertisement
Table of Contents
