Important Points When Using The Bypass Tray - Sharp MX-M283 Operation Manual

Hide thumbs Also See for MX-M283:

Table of Contents

IMPORTANT POINTS WHEN USING THE BYPASS TRAY

• When using plain paper other than SHARP standard paper or special media other than SHARP-recommended

transparency film, or when printing on the reverse side of previously used paper, the paper must be loaded one sheet

at a time. Loading more than one sheet at a time will cause misfeeds.

• Before loading paper, straighten any curling in the paper.

• When adding paper, remove any paper remaining in the bypass tray, combine it with the paper to be added, and

reload as a single stack. If paper is added without removing the remaining paper, a misfeed may result.

Inserting paper

Inserting tab paper

To print on tab paper, load tab paper in the bypass tray with the print side face down.

• Use only tab paper that is made of paper. Tab paper made of a material other than paper (film, etc.) cannot be used.

• To print on the tabs of tab paper...

In copy mode, use "Tab Copy" in the special modes. In print mode, use the tab print function.

Inserting transparency film

Horizontally

Place paper that is 7-1/4" x 10-1/2" (A5) or smaller in the horizontal

orientation.

• Use SHARP-recommended transparency film. When inserting

transparency film in the bypass tray, the rounded corner

should be at the front left when the film is oriented horizontally,

or at the far left when the film is oriented vertically.

• When loading multiple sheets of transparency film in the

bypass tray, be sure to fan the sheets several times before

• When printing on transparency film, be sure to remove each

sheet as it exits the machine. Allowing sheets to stack in the

output tray may result in curling.

BEFORE USING THE MACHINE

Show Quick Links

Table of Contents