Table of Contents
Advertisement
Installation, Maintenance, and Upgrade
•
Install the FIPS Opacity Shield
Note
Because the FIPS opacity shield covers the serial number on the chassis, the CO should copy the serial number
and store it in a secure place. The serial number is needed when you call Cisco TAC. See
Location, on page 6
Note
You can only install the FIPS opacity shield with the desktop mount or wall mount. The rack mount does not
support the FIPS shield. See
28
for more information.
Before you begin
Caution
This procedure should be performed only by the Crypto Officer (CO).
You need the following to install the FIPS opacity shield:
• #1 Phillips head screwdriver
• The following items from the FIPS kit (part number 69-100649-01):
Install the FIPS Opacity Shield , on page 41
for the location of the serial number.
Desktop-Mount the Chassis, on page 28
• One FIPS opacity shield (part number 800-106088-01)
• Three M3 x 66 mm (part number 48-0384-01) screws used to attach the FIPS opacity shield to the
chassis
• Nine Tamper Evidence Labels (TELs) (part number 47-25553-01)
5
C H A P T E R
and
Wall-Mount the Chassis, on page
Cisco Firepower 1010 Hardware Installation Guide
Serial Number
41
Advertisement
Table of Contents
