Table of Contents
Advertisement
Installation, Maintenance, and Upgrade
•
•
Replace the SSD
The Firepower 1100 ships with an SSD installed. You can replace this SSD should it fail. Before replacing
the SSD, you must power off the chassis by pressing the power switch on the rear panel.
Caution
Follow these steps to replace an SSD in the chassis:
Step 1
Loosen the thumb screws on both sides of the SSD bay and pull the existing SSD out of the bay.
Step 2
Insert the new SSD into the bay and push it in until it is seated.
Replace the SSD, on page 33
Install the FIPS Opacity Shield in a Two-Post Rack, on page 34
You will lose your configuration after you replace the existing SSD with a new SSD.
C H A P T E R
Cisco Firepower 1100 Series Hardware Installation Guide
5
33
- Quick Links:
- Front Panel
- Connect to the Console Port
Hide quick links:
Advertisement
Table of Contents
