Page 3
• Install the appliance on a flat hard floor. cases you can use metering balls or sachets provided with the detergent, Take out the metering aid at the end • Never place cardboard, wood or similar materials un- of the washing cycle. der the appliance to compensate for any unevenness in the floor.
To activate this device, ro- To disable this device and tate the button (without restore the possibility of pressing it) inside the closing the door, rotate the door clockwise until the button anti-clockwise un- groove is horizontal. If til the groove is vertical. necessary use a coin.
Ecological hints • With adequate pre-treatment, stains and limited soiling can be removed; the laundry can then be washed at a To save water, energy and to help protect the environment, lower temperature. we recommend that you follow these tips: •...
Water supply pressure Minimum 0,05 MPa Maximum 0,8 MPa Maximum Load Cotton 5 kg Spin Speed Maximum 1200 rpm (ZWF5120P) 1400 rpm (ZWF5140P) Installation Unpacking Warning! • Read carefully the "Safety information" chapter before installing the appliance. • Remove the cardboard top. •...
Page 7
• Remove the power supply cable and the draining and inlet hose from the hose holders ( C ) on the rear of the appliance. • Plug the smaller upper hole and the two large ones with the corresponding plastic plug caps. Positioning and levelling •...
Page 8
Firstly form a hook in the end of the drain hose using the plastic hose guide supplied with the appliance . The end of the drain hose can be positioned in three ways: • Hooked over the edge of a sink using the plastic hose guide.
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your Local Centre. Connections overview 115 cm 140 cm Electrical connection • Make sure that the mains plug and cable is not squash- ed or damaged by the back of the appliance.
Daily use Sort out the laundry Ball point pen and glue : moisten with acetone , lay the garment on a soft cloth and dab the stain. Follow the wash code symbols on each garment label and Lipstick : moisten with acetone as above, then treat stains the manufacturer’s washing instructions.
Page 11
Close the door gently If the water hardness degree is medium or high we suggest you to add a water softener following always the manu- facturer’s instructions. Warning! Make sure When the degree of hardness is soft, readjust the quantity that any fabrics were of the detergent.
Page 12
• Remove the drawer. Push the drawer edge outwards • Pour the liquid detergent in the compartment where indicated by the arrow (PUSH) to facilitate without exceeding the limit indicated in the flap. The drawer removal. detergent must be placed in the appropriate com- partments of the dispenser drawer before starting the The flap is down and you wish to use powder detergent: wash programme.
Page 13
Katoen Jeans Mini 30 Katoen + voorwas 20° 1400 5 overhemden Hoofdwas Katoen eco Extra spoelen Anti-kreuk Synthetica Einde 30° 90° Centrifugeren 40° 60° Fijne was Pompen Spoelen Turn the programme selector dial to the required programme. The selector dial can be turned either clockwise or counter-clockwise. The green pilot light of the button 6 starts flashing: the appliance is now switched on.
Page 14
Spin Reduction By selecting a programme, the appliance proposes automatically the max- imum spin speed provided for that programme. 1400 Press this button repeatedly to change the spin speed, if you want your laundry to be spun at a different speed. The relevant light illuminates. Rinse Hold By selecting this function the water of the last rinse is not emptied out to prevent the fabrics from creasing.
Page 15
Extra Rinse This appliance is designed for saving water. However, for people with very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water. Press simultaneously the buttons 4 and 5 for some seconds: the pilot light 7.2 comes on.
• Turn the programme selector dial to lector dial and any button are not touched, after a few minutes the energy saving system is enabled. The pilot • Select the draining or spinning programme. lights go off. The green pilot light of the button 6 flashes •...
Page 17
Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry SYNTHETICS 60° - (Cold) SPIN REDUCTION , Main wash - Rinses - Maximum spin speed: 1200 rpm for RINSE HOLD , ZWF5120P - 900 rpm forZWF5140P DELAY START ,...
Programme - Maximum and Minimum Temperature - Cycle De- Detergent Com- scription - Maximum Spin Speed - Maximum Fabrics Load - Type Options partment of Laundry SPIN Drain and long spin at maximum spin speed: 1200 rpm for ZWF5120P- 1400 rpm for ZWF5140P Max.
Programme Energy consumption Water consumption (litres) Programme duration (Mi- (KWh) nutes) Cottons 60° 1.10 0.85 Cotton ECO 60° Cottons 40° 0.70 Synthetics 40° 0.55 Delicates 40° 0.55 Wool/ Handwash 30° 0.30 1) «Cottons Eco» at 60°C with a load of 5 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards.
Page 20
• Use the previous brush to clean the recess, en- suring that upper and lower part of it is well cleaned. After having cleaned the dispenser and the drawer re- • remove the filter and clean it under the tap; cess, replace it.
Cleaning the water inlet filters • Screw the hose back onto the tap. Make sure the connection is tight. Important! If the appliance doesn't fill, it takes a long time to fill with water, the starting button flashes red or the •...
Page 22
Fault code and malfunction Possible cause / Solution The drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged. If the appliance stops working without discharging the water , first carry out an emergency drain: •...
Page 23
Malfunction Possible cause / Solution The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. The appliance does not start: •...
Page 24
Malfunction Possible cause / Solution The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.