Main Pto Switch Replacement - Toro Z MASTER 2000 Series Service Manual
Hide thumbs
Also See for Z MASTER 2000 Series:
- Service manual (118 pages) ,
- Operator's manual (32 pages) ,
- Setup instructions (8 pages)
Table of Contents
Advertisement
Control Panel Installation (continued)
Main PTO Switch Replacement
Main PTO Switch Removal
Main PTO Switch Installation
Electrical: Service and Repairs
g421555
9. Using a T30 torx driver, install the 2 (1/4 inch) screws to secure the control
panel to the RH cover panel.
10. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the control panel. Refer to
4. Compress the 2 tabs on the side of the switch and remove the main PTO
switch.
1. Insert the main PTO switch into the control panel.
2. Install the control panel. Refer to
3. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Figure 139
Control Panel Removal (page
Control Panel Installation (page
Page 8–14
8–9).
8–12).
2000 Series Z MASTER®Service Manual
3460-328 Rev A
Hide quick links:
Advertisement
Chapters
Table of Contents
