Backhaul FM3200 Endo
Cisco Ultra-Reliable Wireless
Figure 9. Protective rubber sleeves
Connect the antennas to the unit by doing the following steps:
1.
The number and types of antennas to be connected to the unit
will have been decided at the network design stage. Verify which
antenna will be connected to each RPSMA plug.
2.
Only remove the rubber sleeve from an RPSMA plug if an
antenna must be connected to the plug.
Next, proceed to the steps in the following table:
© 2020 Cisco and/or its affiliates. All rights reserved.
Page 38 of 177