Cisco FLUIDMESH FM3200 Endo Installation And Configuration Manual page 49
Ultra-reliable wireless backhaul
Hide thumbs
Also See for FLUIDMESH FM3200 Endo:
- Installation and configuration manual (189 pages) ,
- Installation and configuration manual (176 pages) ,
- Installation and configuration manual (179 pages)
Table of Contents
Advertisement
Backhaul FM3200 Endo
Cisco Ultra-Reliable Wireless
• If the icon reads Provisioning, the unit is in Provisioning Mode.
Configure the unit by doing the steps shown in this section.
• If the icon reads Online or Offline, the unit has been configured
before. In this case, you must choose between two further options:
• If you want to do a new configuration by reverting the unit to
Provisioning Mode, reset the unit as shown in
unit to factory defaults" (page
• If you want to change the connection settings, but keep the
current configuration, change the settings as shown in
"General settings" (page
If the Cisco FM3200 Endo is in Provisioning Mode:
• The RACER™ dialog will be shown
Figure 14. FM Racer dialog
• The unit's Local IP address will be set to 169.254.a.b, where a and
b are the last two parts of the unit's unique unit identification (ID)
number. For example, if the unit ID number is 5.12.34.56, the unit's
IP address will be set as 169.254.34.56.
• The unit can also be reached using the DHCP fallback IP address
(192.168.0.10/24).
• The unit's Status and link/boot LEDs will blink continuously from left
to right (green-green-orange-red), then from right to left (red-
© 2020 Cisco and/or its affiliates. All rights reserved.
139).
56).
(Figure 14 (page
"Resetting the
49)).
Page 49 of 177
Advertisement
Table of Contents
