Table of Contents
Advertisement
Filling the Engine with Oil
You snowthrower comes with only a few ounces of oil
in the engine. Before starting the engine, add oil.
Note: The bottle that comes with the snowthrower
contains 25 oz. of oil.
Max. fill: 26 oz. (0.77 l), type: automotive detergent oil
with an API service classification of SF, SG, SH, SJ,
SL, or higher.
For temperatures above 32 F (0 C), use
SAE 30W.
For temperatures between 0 F and 32 F (–18 C
to 0 C), use SAE 5W30 or SAE 10W.
For air temperatures below 0 F (–18 C), use
SAE 0W30.
1. Remove the
dipstick.
2. Slowly pour oil
into the oil fill tube
to raise the oil level
to the Full mark on
the dipstick. Do
not overfill.
3. Install the
dipstick securely.
Note: Do not spill
oil around the oil fill
tube; oil could leak
onto traction parts
and cause the
traction to slip.
Checking the Tire Pressure
The tires are overinflated at the factory for shipping.
Reduce the pressure equally in both tires to between
17 and 20 psi (116 and 137 kPa).
Checking the Skids
Refer to Checking and Adjusting the Skids on
page 16.
9
Before Operating
Freewheeling or Using the
Self-propel Drive
You can operate the snowthrower with the self-propel
feature engaged or disengaged (freewheeling).
To freewheel, slide the
wheels inward and insert
the axle pins through the
outer axle holes, but not
through the wheel hubs.
To self-propel, slide the
wheels outward and
insert the axle pins
through the holes in the
wheel hubs and the
inner axle holes.
m-6900
3329-779
m-6902
m-6902
Advertisement
Table of Contents
