Cisco Aironet 1815w Getting Started Manual page 4

Hide thumbs

Table Of Contents

802.11ac based Transmit Beamforming

–

Quality of Service (QoS)

–

Radio Resource Management (RRM)

–

Rogue Detection

–

BandSelect

–

Integrated Bluetooth LE 4.1 radio for location and asset tracking.

–

• The AP supports the following hardware external interfaces:

Three local GigE Ethernet Ports, one uplink GigE port, and one passive pass-through RJ45

–

port.

RS-232 management console interface through a custom 4-pin connector AIR-CONSADPT=.

–

The AP may face issues while booting if you use an unterminated console cable (not

Note

plugged into any device or terminal) or a console cable that is more than one meter in

length.

Three 10/100/1000BASE-T ports (local Ethernet ports), one of which also serves as a PoE-Out

–

port.

The PoE-Out port 802.3af Class 0 (15.4W) power when the AP is powered by802.3at power.

The PoE-Out port does not provide any power output when the AP is powered by 802.3af

power.

One RJ-45 passive pass-through port (back to bottom).

–

Mode button. For information on how to use the Mode button, see

–

section on page

One multi-color LED status indicator for the AP status. LEDs are also present to indicate

–

per-port status for local the Ethernet ports. For information, see the

Point LEDs" section on page

Three local Gigabit Ethernet ports available to securely connect wired devices to the network.

–

• Two integrated 2.4 GHz/5 GHz dual-band antennas located on the sides of the 1815w access point

under the top housing. Peak antenna gain is approximately 2 dBi and 3 dBi in the 2.4 GHz and

5 GHz bands respectively.

36.

33.

"Using the Mode Button"

"Checking the Access

Table of Contents

Cisco Aironet 1815w Getting Started Manual page 4

Related Manuals for Cisco Aironet 1815w

Related Products for Cisco Aironet 1815w