Advertisement
Available languages
Available languages
brought to the appropriate position, rpm and
temperature data reappear.
Switching the machine to standby
mode
Press "Start/Pause/Cancel" button
momentarily to switch your machine to the
standby mode. Auxiliary functions can be
cancelled or selected in accordance with
the step the program is at. The door can be
opened if the water level is suitable. Laundry
may be added / taken out by opening the
door.
Door lock
The Door Locked Symbol (Figure 2-7i) lights
up when the loading door is locked. This
symbol will flash until the door is allowed to
open. Do not force the door at this stage. You
may open the door after the symbol fades out.
Child-proof lock
You can protect the appliance from being
tampered by children by means of the child-
proof lock. In this case, no change can be
made in the running program.
The machine is switched to child-lock by
pressing the 2nd and 4th auxiliary functions
for 3 sec. "C:on" (Child lock is activated) label
appears on the screen. The same symbol
will also be displayed whenever any button is
pressed while the machine is child-locked.
To deactivate the child-proof lock, press the
2nd and 4th auxiliary function buttons for 3
sec. "C:OFF" (Child lock is deactivated) label
appears on the screen.
Ending the program through
canceling
"Start/Pause/Cancel" button is pressed for 3
seconds to cancel the program. Start symbol
(Figure 2-7j) will flash during cancellation. After
cancellation, the symbol of the corresponding
step at which the cancellation was made will
remain lit and "End" will appear on the screen.
End of program
When the program is finished, the symbols
of the relevant steps will remain lit up and
the auxiliary function, spin and temperature
data selected at the start-up of the program
will remain selected. "End" will appear on the
display.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards
you until the compartment is removed from
the machine.
C
If more than a normal amount of water
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its
original location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where
they are connected to the tap. These filters
prevent the foreign substances and dirt in the
water to enter into the machine. Filters should
be cleaned as they get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses
to clean the surfaces of the filters on the
water intake valves with an appropriate
brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
• Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
streaming water.
• Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.
9 - EN
Advertisement
