6ADP 8966
Program selector knob
Mains On / Off
Start button
Switches "on" when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Add rinse aid
Wash cycle
Pre-Rinse
Washing
Programme chart
Programmes
Sensor Wash
Sensor Intensive
Pre-Rinse
Glass
Quickwash
1)
Normal
1)
Reference program for energy label compliance with
AS/NZS 2007;
2)
Refer to "User instructions";
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
"nk_customer@email.whirlpool.com".
Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Programme
Drying
end
Loading instructions
Automatic programme recommended
40-55°C
for routine washes, with no dried-on
or burnt food (not for EN 50242).
Automatic programme recommended
for heavily soiled crockery with dried-
60-70°C
on or burnt food, for example pans and
saucepans.
cold
Crockery to be washed later.
Light soiling, for example glasses and
40°C
cups.
Lightly soiled crockery with no dried-
40°C
on food.
40°C
Normally or heavily soiled crockery.
Options
"Half load - Multizone" button
Load the upper or lower rack only.
This function can be used with any programme.
Press once = upper rack (the indicator lamp comes on)
Press twice = lower rack (the indicator lamp comes on)
Press 3 times = Off (half load function deactivated).
Time and failure display
Indicates in hours the time remaining until the
start of the wash cycle. Toward the end of the
programme, during the drying cycle, the display
will indicate the time remaining in minutes.
"F..." Identification of faults for service technician
"Delayed start" button
The wash cycle can be programmed to start after 1 -
24 hours. With each successive touch of the button,
the delayed start indicator increases by 1 hour, and
after 24 returns to 00. Then press the Start button.
The dishwasher will start at the set time.
2)
Detergent
A
B
X
X
X
X
-
-
X
-
X
-
X
X
3)
Program data obtained in conformity with European standard
EN 50242. Values may vary in relation to usage, e.g.:
different loads, water temperatures - above or below 15°C -
as well as water hardness and power supply voltage, etc.
(We reserve the right to make technical modifications)
GB
3)
3)
Consumption
Litres
kWh
Minutes
10.0-13.0 0.80-1.05
50-110
13.0-20.0 1.10-2.00
90-140
4.0
0.03
14
10.0
0.80
55
10.0
0.65
30
17.0
0.89
98
5019 396 91275
WH/I/K/AUS