Table of Contents
Advertisement
Quick Links
Quick reference guide
PROGRAM SELECTION
START/RESUME BUTTON
BUTTON
Push this button to start the selected program: the
Push "Programs" button
indicator lights up and goes off at the end of the
(repeatedly) until the indicator
program.
of the required program lights
When the door is opened during a washing cycle,
up (see "Table of programs"
the cycle is temporarily paused: the Start indicator
below).
blinks. To resume the cycle close the door and
push Start button again.
Table of programs
P
Programs
1
Pre-Wash
cold
2
Fragile
40°C
3
Rapid
45°C
4
2)
50°C
Eco
5
Intensive
65°C
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without
additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs
as a result of the appliance's automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed
information on the EN/Standard loading comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
(see at right for options description)
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see page 6 -
chapter "What to do if ...".
Available
Loading instructions
options
Delay
Crockery to be washed later.
Light soiling, for example glasses
Delay
and cups.
Lightly soiled crockery, with no
Delay
dried-on food.
Normally soiled crockery.
Delay
Energy-saving program.
Recommended program for heavily
Delay
soiled crockery, especially suitable for
pans and saucepans.
Options and display description
SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir
needs to be refilled.
Consumption
Deter-
Drying
gent
Phase
1)
Litres
kWh
Minutes
—
4.0
0.03
14
NO
X
10.0 0.85
100
Light
X
11.0 0.80
30
NO
X
12.0 1.15
150
Full
TABLET SETTING
This setting allows to optimize the cycle performances
according the type of detergent used.
X
14.0 1.60
145
Full
Push the Tablet button for 3 seconds (until the indicator
lights up) if you are using the combined detergents in
tablet (rinse aid, salt and detergent in 1 dose).
If you are using powder detergent or liquid detergent,
the Tablet indicator on the control panel has to be off.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
Chart
RINSE AID INDICATOR
When lit (at the end of the
cycle), the rinse aid
dispenser needs to be
refilled.
DELAYED START
BUTTON
The wash cycle can be
programmed to start
after 2, 4 or 8 hours.
Then press the Start
button. The wash
program will start after
the set time.
5019 396 03647
GB -1-
Advertisement
Table of Contents
