Table of Contents
Advertisement
Figure 87
1. Spring
24.
Push the left wing deck back to the center deck.
Align and install the upper pivot deck pins in the
front and rear of the deck and secure it using the
previously removed bolts
25.
Align the lift-cylinder arm and install the
previously removed pin and ensure that the
locking tab aligns with the associated opening
in the mount.
Install the locking cotter pin to secure.
26.
Attach the spring that was removed in step
that applies pressure to the rear of the wing
deck cover.
27.
Install the wing deck belts.
28.
Install the wing deck belt shields and secure
them using the lynch pins.
29.
Raise the wing decks to the T
and secure them using the clevis pins and
hairpin cotters.
30.
Install the height-of-cut pin.
g351417
(Figure
85).
23
position
RANSPORT
Adjusting the Wing Deck
Caster-Pivot Bearings
Service Interval: Every 200 hours/Yearly (whichever
comes first)
1.
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the dust cap from the caster and tighten
the locknut
(Figure
4.
Tighten the locknut until the spring washers are
flat, and then back off a 1/4 turn to properly set
the preload on the bearings
Important:
Make sure that the spring
washers are installed correctly as shown in
Figure
88.
5.
Install the dust cap
1. Spring disc washers
65
88).
(Figure
88).
(Figure
88).
Figure 88
g228558
Advertisement
Table of Contents
