Table of Contents
Advertisement
iPF680
Pack the printer
1
Disconnect the power cord and interface cable.
•
Turn off the printer before you unplug it. It may damage the printer if you unplug it before it is off and transfer
it in that state. If you accidentally unplug the printer, plug it in again, reinstall the ink tanks, and follow this
Important
procedure again.
2
Tape down printer covers to secure them, in the reverse or-
der of tape removal during installation.
3
Remove the Stand by reversing the installation procedure, when it was attached to the printer.
4
Disassemble and repackage the Stand by following the installation procedure in reverse.
5
Repack the Roll Holder, Holder Stopper, and printer in shipping materials, and then package them in a shipping
box.
Reinstalling the Printer
Reinstalling the Printer
The basic workflow for reinstalling the printer is as follows.
For detailed instructions, see the Setup Guide.
Assemble the stand (optional)
1
If you are using the optional Stand, assemble the Stand by refer-
ring to the Printer Stand Setup Guide included with the Stand.
User's Guide
Reinstalling the Printer
571
Advertisement
Table of Contents
Troubleshooting
