Table of Contents
Advertisement
Connecting to the SFP Port of the Access Point
1
SFP port connected using M12 adapter
2
RJ-45 port connected using M12 adapter
Connecting to the SFP Port of the Access Point
Connect to the SFP port by using a cable gland or an M12-RJ45 adapter.
Note
Connecting to SFP Port Using Cable Gland
Follow these steps to connect to the SFP port using cable gland:
SUMMARY STEPS
1. Insert the fiber SFP into the chassis.
2. Disassemble the fiber adapter and slide parts over fiber cable in the order shown in the following figure:
3. Plug the fiber cable into the SFP.
4. Thread the adapter body (with O-Ring) into the chassis.
5. Insert the grommet into the ferrule, and press it into the adapter body.
6. Tighten the clamp nut onto the adapter body until the grommet compresses onto the fiber cable.
DETAILED STEPS
Step 1
Insert the fiber SFP into the chassis.
Step 2
Disassemble the fiber adapter and slide parts over fiber cable in the order shown in the following figure:
Cisco Catalyst IW9167E Heavy Duty Access Point Hardware Installation Guide
44
Copper SFP or Fiber SFP will be detected by the system only after a power cycle.
3
DC power port connected using M12 adapter
Installation Overview
- Quick Links:
- Antennas and Radios
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
