Advertisement
7 Enrolling the Sensor
Refer to the control panel's programming instructions.
1.
Put control panel into
PROGRAMMING/CONFIGURATION mode.
2.
Using a programmed alphanumeric keypad, step through
menu options until "ADD A NEW DEVICE" is displayed.
3.
Select OK or YES. "PRESS PROGRAM BUTTON OF
DEVICE" is displayed.
4.
Press and release program button on the OMV-VX. LED
will flash rapidly.
5.
Wait for keypad to display: MOTIONVIEWER (1 - 25)
PROGRAMMED.
a.
Press OK/YES, the keypad display: RADIO RANGE
TEST?
b.
Press OK/YES again.
The camera LED starts flashing and keypad
displays: "RF TEST".
6.
Place the OMV-VX camera in its intended mounting
location and make sure LED flashes continuously or you
receive a 9/9 indicating good communication with the
control panel.
7.
Press OK/YES to end radio range test then press
ESC/NO.
8.
The keypad displays:
AREA ALLOCATION :
AREA : 1
9.
Press either arrow button repeatedly until a desired area
number appears then press OK/YES. (By default all
devices in Area 1 are automatically delayed.) The
keypad displays: "NAME + LOCATION".
10. Enter appropriate device name/location (up to 16
characters), then press OK/YES. The keypad displays
the device number and name for your verification.
Adjust PIR Sensitivity
To adjust the PIR sensitivity of the OMV-VX, enter the "$"
symbol and numeric after Detector name in step 10 as
follows:.
(Detector name) $9 : Max sensitivity
(Detector name $8 : Improved sensitivity
(Detector name)
: Default sensitivity
(Detector name) $1 : Decreased sensitivity
(Detector name) $2 : Minimal sensitivity
How to enter the symbol "$" (Example)
CMA keypad : Press @ key repeatedly until "$" is
displayed.
XMA/XMB keypad : Press "1" key repeatedly until "$" is
displayed.
11. Press OK/YES. The display shows FUNCTIONAL
DEVICE TEST?
12. Press OK/YES and verify camera operation. The
activation of the LED will determine the detection field.
13. Press OK/YES to end detection verification. The keypad
displays "OPERATION COMPLETED" or "ADD A NEW
DEVICE".
14. Press YES/OK. Repeat steps 4 - 14 to enroll additional
devices.
15. When finished, exit from configuration mode.
PROGRAMING/
CONFIGURATION
ADD A NEW
DEVICE ?
OK or YES
PRESS PROGRAM
BUTTON OF DEVICE
MOTIONVIEWER
(1-25) PROGRAMMED
OK or YES
RADIO RANGE
TEST ?
OK or YES
RF TEST
OK or YES
ESC/NO
AREA ALLOCATION :
AREA 1
OK or YES
(name + location)
Up to 16 characters
OK or YES
FUNCTIONAL
DEVICE TEST ?
OK or YES
FUNCTIONAL
DEVICE TEST ?
OK or YES
Detected
OK or YES
ADD A NEW
DEVICE
OK or YES
Repeat step 4-13
- 4 -
Program
Button
Enter name + location
Not
detected
Check camera &
detection area
OPERATION
COMPLETED?
OK or YES
Exit
Advertisement
