Running The Simulator - Cisco Touch10 Manual

In-room control

Hide thumbs Also See for Touch10:

Table of Contents

Room Simulator

Running the Simulator

In order to make it possible to demonstrate the features of the In-

Room Control, we have made a simulator for you. The simulator

should primarily be regarded as a sales tool.

No external controller is needed when running the simulator.

The simulator uses a predefined In-room Control setup. This

cannot be changed. The predefined setup will overwrite the

setup in the codec. Your current setup will be backed up in your

browser and reinstalled after the session (you will be prompted to

confirm that).

Note! As the simulator is self-contained, any controller connected

to the codec should be disconnected when running the simulator

to avoid conflicts.

Tip! We recommend using Google Chrome browser when

running the simulator. Other browsers may fail to run the simulator

properly.

To invoke the simulator navigate to Integration > In-Room

Control in the web interface and then select Launch Simulator:

The Example Room will now appear. Click on Load Simulator

Config. Once succesfully loaded click anywhere to remove

messages when needed.

Click on the Touch (1) to enlargen it and then click as shown (2)

to invoke the In-Room Controls:

You may now play with the controls on the virtual Touch, but also

with the switches themselves in the room. Click Clean up to finish

and restore previous settings.

Table of Contents