Advertisement
Quick Links
PORTABLE AUDIO SYSTEM
RA-P10
For Customer Use:
Enter below the Model No. and Serial No.
which are located either on the rear, bot-
tom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
INSTRUCTIONS
LVT1634-001B [J]
Warnings, Cautions and Others / Mises en garde, précautions et indications diverses
(For U.S.A)
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol,
within an equilateral triangle is intended to
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure
that
may
be
of
sufficient
magnitude to constitute a risk of electric
(For U.S.A)
shock to persons.
This equipment has been tested and found to comply
The exclamation point within an equilateral
with the limits for a Class B digital device, pursuant
triangle is intended to alert the user to the
presence of important operating and
to part 15 of the FCC Rules. These limits are
maintenance (servicing) instructions in the
designed to provide reasonable protection against
literature accompanying the appliance.
harmful interference in a residential installation.
This equipment generates, uses and can radiate
(For U.S.A)
radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
WARNING: TO REDUCE THE RISK OF FIRE
harmful interference to radio communications.
OR ELECTRIC SHOCK, DO NOT EXPOSE
However, there is no guarantee that interference will
THIS APPLIANCE TO RAIN OR MOISTURE.
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
(For U.S.A)
CAUTION
Changes or modifi cations not approved by JVC
• Rating label is placed on the exterior of the bottom.
could void the user's authority to operate the
equipment.
EN
©2006 Victor Company of Japan, Limited
0906NSMCREBET
Precautions
For Canada/pour le Canada
• Install in a place which is level, dry and neither too
THIS DIGITAL APPARATUS DOES NOT
hot nor too cold–between 5°C and 35°C (41°F and
EXCEED THE CLASS B LIMITS FOR
RADIO NOISE EMISSIONS FROM DIGITAL
95°F).
APPARATUS AS SET OUT IN THE
• Install the System in a location with adequate
INTERFERENCE-CAUSING EQUIPMENT
ventilation to prevent internal heat buildup inside
STANDARD ENTITLED "DIGITAL APPARATUS,"
the System.
ICES-003 OF THE DEPARTMENT OF
COMMUNICATIONS.
DO NOT install the System in a location
near heat sources, or in a place subject to
CET APPAREIL NUMERIQUE RESPECTE LES
direct sunlight, excessive dust or vibration.
LIMITES DE BRUITS RADIOELECTRIQUES
APPLICABLES AUX APPAREILS NUMIRIQUES
DE CLASSE B PRESCRITES DANS LA NORME
• Leave suffi cient distance between the System and
SUR LE MATERIEL BROUILLEUR; "APPAREILS
the TV.
NUMERIQUES", NMB-003 EDICTEE PAR LE
• Keep the speakers away from the TV to avoid
MINISTRE DES COMMUNICATIONS.
interference with TV.
Caution: Proper Ventilation
To avoid risk of electric shock and fi re, and to prevent damage, locate the apparatus as follows:
Front: No obstructions and open spacing.
Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.
Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand
15
with a height of 10 cm (3-
/
"
) or more.
16
Attention: Aeration correcte
Pour prevenir tout risque de decharge electrique ou d'incendie et eviter toute deterioration, installez l'
appareil de la maniere suivante:
Avant: Bien degage de tout objet.
Cotes/dessus/dessous: Assurez-vous que rien ne bloque les espaces indiques sur le schema ci-
dessous.
Dessous: Posez l'appareil sur une surface plane et horizontale. Veillez a ce que sa ventilation correcte
puisse se faire en le placant sur un support d'au moins dix centimetres de hauteur.
Front
Side
Face
Côté
15cm
15cm
15
(5-
/
")
(5-
15
/
")
16
16
15cm
15cm
15cm
15
15
15
(5-
/
")
(5-
/
")
(5-
/
")
16
16
16
10cm
15
(3-
/
")
16
Getting Started
Insulation sheet
Supplied Accessories
Prepare the Remote
Control
After unpacking, check to be sure
• When you use the remote
that you have all the following items.
control for the fi rst time, pull
out the insulation sheet.
• Remote control
• AC adaptor
(Front side)
• Attachments (6 types)
Replacing the Battery
• Rubber pads (A type×2, B type×2)
in the Remote Control
• CR2025 (×2) lithium coin batteries
• Insert the battery into the
One is loaded on the remote
remote control by matching
control at the factory.
the polarity (+ and –)
correctly.
(Rear side)
Preparation of the Unit
Loading batteries for the Unit (The battery power supply)
Insert three batteries to each compartment (six batteries total). Be sure to match the poles (+/-) correctly.
While the AC adaptor is connected to the wall outlet, the unit works without batteries.
R6 (SUM-3)/AA (15F) (not supplied)
Open the battery compartment
cover by pressing the small tab.
Close the cover in the order shown by the numbers.
9V 1.5A
Connecting the AC adaptor
Loading batteries for the Clock
Be sure to match the poles (+/-) correctly.
Lithium coin
battery
(CR2025)
9V 1.5A
(supplied)
AC adaptor: AA-R9028 (supplied)
CAUTION:
To avoid risk of fi re, and to prevent damage.
Press the tab to open
Close the cover in the order
• Do not use AC adaptors except for the supplied AC adaptor.
the cover.
shown by the numbers.
• Do not use the supplied AC adaptor for other equipment.
Troubleshooting
If you are having a problem with your System, check this list for a possible solution before calling for service.
In These Cases
Check the following points
Power does not come on.
• AC adaptor is not inserted securely. Plug in securely.
• The batteries are exhausted.
No longer works.
Press the "RESET" button (see "Resetting the unit").
Cannot set the iPod.
• Is the selected attachment compatible to your iPod? Confi rm the
compatibility of iPod and attachments in "iPod Compatibility Chart".
• Is the attachment properly mounted on the unit? Make sure to mount the
attachment properly.
Cannot operate iPod.
• Is the iPod fi rmly connected to the connector plug of the unit?
• Is the iPod properly functioning? Test the iPod functions in stand alone
condition.
iPod cannot be charged.
• Is the iPod fi rmly connected to the connector plug of the unit?
• Is the AC adaptor connected? The iPod cannot be charged while the Unit
is operated on batteries.
• For iPod 3rd Generation, set the "CHARGING SWITCH" to "FIREWIRE"
(see "Charging the iPod").
Hard to listen to broadcasts
The FM antenna is not properly extended and positioned.
because of noise.
Unable to operate the System
• The path between the remote control and the remote sensor on the
from the remote control.
System is blocked.
• The batteries are exhausted.
When the volume level is
The unit's battery runs low (The "---" (Low battery) appears on the display).
manually set higher than "08",
Replace the batteries with new ones.
the unit automatically lowers
the level to "08".
Resetting the unit
If "Troubleshooting" does not eliminate malfunctioning (failure to operate or
display properly, etc.), press the "RESET" button on the rear of the unit with
something having a sharp point, while the unit is turned on. After pressing
"RESET" button, unplug the AC adaptor and wait a while before plugging it
again.
• When using "RESET" button, make sure the lithium coin battery is loaded.
• While resetting the unit, the clock is also reset. Adjust the clock after resetting
the unit.
Warning
• Store the battery in a place where children cannot reach. If a child accidentally swallows the battery,
consult a doctor immediately.
• Do not recharge, short, disassemble or heat the battery or dispose of it in a fi re. Doing any of these things
may cause the battery to give off heat, crack, or start a fi re.
• Do not leave the battery with other metallic materials. Doing this may cause the battery to give off heat,
crack, or start a fi re.
Lithium
• When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may start to
coin battery
give off heat, crack, or start a fi re.
(CR2025)
• Do not poke the battery with tweezers or similar tools. Doing this may cause the battery to give off heat,
crack, or start a fi re.
• Dispose of battery in the proper manner, according to federal, state, and local regulations.
• The batteries (battery pack or batteries installed ) shall not be exposed to excessive heat source such as
sunshine, fi re or the like.
For USA-California Only
This product contains a CR Coin Cell Lithium Battery which contains Perchlorate Material – special handling
amay apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Operating on the Remote Control
SOURCE button
1
Switch the sound source.
FM MODE button
2
5
Switch FM stereo/monaural.
MUTING button
3
Turn off the sound. Return to original mode by
6
1
pressing again.
FM wire antenna
PRESET +/- button
7
4
(Pass through the notch in the cover)
Select a registered FM radio station (P01 to 20).
2
iPod 6 button
8
5
Play/pause the iPod.
3
button
6
4
To a wall outlet
Switch the backlight on/off.
Plug the AC adaptor
4/¢ button
7
only after all connections
Fast-forward/rewind the iPod song.
Change frequencies to tune in to FM radio
are completed.
station.
VOLUME +/- button
8
You can adjust the volume level from 00 to a
maximum of 20.
NOTES
• Point the remote control at the remote control sensor on the front panel.
• The remote control sensor is designed to receive signals from up to
approximately 7 m distance when the remote control is pointed directly. If the
remote control is pointed with an angle, the distance may become shorter.
Specifi cations
Model
RA-P10
Type
Portable audio system
Power Output
4W x 2
Amplifi er
1kHz 10% THD, 6Ω
Input Sensitivity/ Impedance
AUX Input
250mV/47kΩ
Tuning Range
87.5MHz - 108.0MHz
FM Tuner
Frequency Step
100kHz
Preset Stations
20
Speaker
1way full range, diameter 35mm x2
External DC IN ( for AC adaptor)
Input Terminal
AUX IN (mini jack)
DC9V
1.5A (EXTERNAL DC IN)
Power Source
DC9V
(SIZE R6, AA BATTERY OR EQUIVALENT x6)
DC3V
(CR2025, for the clock)
Input : AC 110-240V , 50/60Hz
AC adaptor
Output : DC 9V
1.5A
Dimensions (W x H x D)
(W) 331 mm x (H) 71 mm x (D) 98 mm (13-
Weight (Without batteries)
0.7kg (1.6 lbs)
Accessory
See Supplied Accessories
Specifi cations and appearance are subject to change without prior notice.
1
/
x 2-
13
/
x 3-
7
/
)
"
"
"
16
16
8
Advertisement
Related Manuals for JVC RA-P10J
Summary of Contents for JVC RA-P10J
- Page 1 Consult the dealer or an experienced radio/TV technician for help. (For U.S.A) CAUTION Changes or modifi cations not approved by JVC • Rating label is placed on the exterior of the bottom. could void the user’s authority to operate the equipment.
- Page 2 For details about updating your iPod, check on the Apple web site <http://www.apple.com>. • iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries. • JVC is not responsible for any loss of or damage to iPod that might result from the use of this product.