Inspecting And Replacing Anode(S); Checking Battery (For Electric Start Models) - Yamaha F75 Owner's Manual
Hide thumbs
Also See for F75:
- Owner's manual (234 pages) ,
- Installation manual (224 pages) ,
- Maintenance manual (36 pages)
Table of Contents
Advertisement
Maintenance
6.
Put a new gasket on the oil level plug.
When the oil begins to flow out of the oil
level plug hole, insert and tighten the oil
level plug.
Tightening torque:
9.0 Nm (0.92 kgf-m, 6.6 ft-lb)
7.
Put a new gasket on the gear oil drain
screw. Insert and tighten the gear oil
drain screw.
Tightening torque:
9.0 Nm (0.92 kgf-m, 6.6 ft-lb)
EMU29312
Inspecting and replacing anode(s)
Yamaha outboard motors are protected from
corrosion by sacrificial anodes. Inspect the
external anodes periodically. Remove scales
from the surfaces of the anodes. Consult a
Yamaha dealer for replacement of external
anodes.
ECM00720
NOTICE
Do not paint anodes, as this would render
them ineffective.
TIP:
Inspect ground leads attached to external an-
odes on equipped models. Consult a Yamaha
dealer for inspection and replacement of inter-
nal anodes attached to the power unit.
78
ZMU03274
EMU29322
Checking battery (for electric start
models)
EWM01900
WARNING
Battery electrolytic fluid is poisonous and
caustic, and batteries generate explosive
hydrogen gas. When working near the bat-
tery:
Wear protective eye gear and rubber
G
gloves.
Do not smoke or bring any other source
G
of ignition near the battery.
Refer to page 15 for detailed safety infor-
mation about batteries.
The procedure for checking the battery varies
for different batteries. This procedure con-
tains typical checks that apply to many batter-
ies, but you should always refer to the battery
manufacturer's instructions.
ZMU04245
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
