Table of Contents
Advertisement
If the spine module RS-232 port is connected to a terminal emulation program, the user will be able to
Note
view the switch boot process. Be certain to use a null-modem/crossover serial cable for the console port.
The settings for the terminal emulation device should be:
Figure 1-11 SFS 7012 RS-232 Connector
Step 3
The system prompts for a user name. In order to change the IP address and default gateway, the user must
be logged in as the administrator. At the prompt enter:
The system prompts for a password. At the prompt enter:
Step 4
The system responds with:
Verify the IP address with the command line interface (CLI) command showChassisIpAddr
Step 5
command. The system returns the information similar to the following:
Changing the IP Address and Default Gateway
There are 3 methods to change the IP address and default gateway of the chassis:
•
•
OL-8787-05
8 data bits
–
–
no parity bits
–
1 stop bit
–
57600 baud
Use VT100 emulation.
–
–
Flow control = XON/XOFF
3 (Unmanaged)
2 (Managed)
1 (Managed)
PS
3
super
super
Welcome to the SFS 7012 CLI. Type 'list' for the list of commands.
Chassis IP Address:
Using the serial port.
Logging into the CLI over Ethernet from a system that can reach the chassis using the default IP
address (192.168.100.9).
Fan
3
Fan
PS
PS
1
2
1
192.168.100.9
Net mask: 0xffffff00
Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide
Spine Module
RS-232 Port
1-21
Advertisement
Table of Contents
