Ending A Cli Session; Ctms Cli Commands - Cisco MCS 7800 Series Administration Manual
Cisco systems multipoint switch administration guide
Hide thumbs
Also See for MCS 7800 Series:
- Administration manual (360 pages) ,
- Administrator's manual (234 pages) ,
- User manual (112 pages)
Table of Contents
Advertisement
Ending a CLI Session
From a remote system, use SSH to connect securely to CTMS. In the SSH client, enter the following
Step 1
information: ssh adminname@IP Address
•
•
When the system prompts you, enter the password.
Step 2
The CLI prompt (admin) displays. You can now enter any CLI command.
Step 3
The prompt will always be "admin."
Note
CLI Command Basics
•
•
•
•
Ending a CLI Session
To end a CLI session:
At the CLI prompt, enter quit.
Step 1
CTMS CLI Commands
The following CLI commands are used with Cisco TelePresence Multipoint Switch:
•
•
•
•
•
•
•
•
•
Cisco TelePresence System Release 1.4 Administrator's Guide
A-2
adminname is the Admin ID
IP Address is the IP address of CTMS
Enter the beginning of a command and press Tab to have the system complete the command for you.
Enter a full command and press Tab to display all commands or subcommands that are available. If
you press Tab and the current command line repeats, no additional expansions are available.
To get detailed help, enter help command name at the CLI prompt.
To get command syntax for a particular command, enter command name? at the CLI prompt
confmgmt, page A-5
media GetDSCP, page A-6
set bad_ep_detect, page A-7
set commandcount, page A-8
set conferencetermination, page A-9
set cuvcdialrepeatinterval, page A-10
set cuvcdialrepeattime, page A-11
set damping, page A-12
set feedbackwaitbasetime, page A-13
Appendix A
Command Line Interface (CLI) Commands
OL-12586-02
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
