Command Line Interface (Cli) Commands; Tables Of Contents; Introduction; Starting A Cli Session - Cisco MCS 7800 Series Administration Manual
Cisco systems multipoint switch administration guide
Hide thumbs
Also See for MCS 7800 Series:
- Administration manual (360 pages) ,
- Administrator's manual (234 pages) ,
- User manual (112 pages)
Table of Contents
Advertisement
Command Line Interface (CLI) Commands
Initial Release: August 4, 2008, OL-12586-02
Tables of Contents
•
•
•
•
•
Introduction
This chapter explains how to use Cisco TelePresence Multipoint Switch (CTMS) Command Line
Interface (CLI) commands.
Starting a CLI Session
You can access the CTMS CLI through the physical console or remotely. If accessing the CTMS CLI
remote, use Secure Shell (SSH) from a personal computer or workstation to connect securely to CTMS.
Before you begin, be sure that you have the following information:
•
•
You will need this information to log into CTMS.
The admin ID and password can be changed from the default in the Cisco Unified Communications
Note
Manager (Unified CM) for CTMS device page.
To start a CLI session:
OL-12586-02
"Introduction" section on page A-1
"Starting a CLI Session" section on page A-1
"CLI Command Basics" section on page A-2
"Ending a CLI Session" section on page A-2
"CTMS CLI Commands" section on page A-2
CTMS IP address
Admin ID and password
A P P E N D I X
Cisco TelePresence System Release 1.4 Administrator's Guide
A
A-1
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
