Table of Contents
Advertisement
Getting Started
Connecting to the Switch
NOTE
STEP 1
ESW 500 Series Switches Administration Guide
If you will be using this PC for further switch configuration, it will need to be
NOTE
on the same subnet as the switch.
Using a Dynamic IP Address Allocated to the Switch By DHCP
If this method of obtaining an IP address is used, you will need to have access to a
configuration device that would allow you to see what IP addresses the DHCP
server allocates. Prior to choosing this method of installation, speak with your
network administrator to ensure you will have the correct information available to
you.
By default, the IP address of the device is assigned dynamically.
Log on to the DHCP server and check the IP address corresponding to the Media
Access Control (MAC) address of the switch. On the 24 and 48 port models, the
MAC address is on the back panel of the switch next to the power adapter. On the
8 port models, the MAC address is on the bottom of the device. The illustration
below shows a MAC address of 00211BFE7218.
Once you have the correct IP address that has been assigned to the switch, you
can begin configuring the switch.
Open a web browser. Cisco recommends Internet Explorer version 6 or higher, or
Firefox version 3 or higher.
Enter the IP address that has been assigned to the switch in the address bar and
Log In page
press Enter. The
opens:
1
11
Hide quick links:
Advertisement
Table of Contents
