Cisco Catalyst 3750E-48PD-F Getting Started Manual page 7

Cisco systems hub/switch getting started guide

Hide thumbs Also See for Cisco Catalyst 3750E-48PD-F:

Table of Contents

(Optional) You can select the Advanced Settings tab on the Express Setup window and enter

Step 15

the advanced settings now or enter them later by using the device manager interface.

(Optional) Enter this information in the Advanced Setting fields:

Step 16

• In the Telnet Access field, click Enable if you are going to use Telnet to manage the

switch by using the command-line interface (CLI). If you enable Telnet access, you must

enter a Telnet password.

• In the Telnet Password field, enter a password. The Telnet password can be from 1 to

25 alphanumeric characters, is case sensitive, allows embedded spaces, but does not

allow spaces at the beginning or end. In the Confirm Telnet Password field, re-enter the

Telnet password.

• In the SNMP field, click Enable to enable Simple Network Management Protocol

(SNMP). Enable SNMP only if you plan to manage switches by using CiscoWorks 2000

or another SNMP-based network-management system.

• If you enable SNMP, you must enter a community string in the SNMP Read Community

field, the SNMP Write Community field, or both. SNMP community strings

authenticate access to MIB objects. Embedded spaces are not allowed in SNMP

community strings. When you set the SNMP read community, you can access SNMP

information, but you cannot change it. When you set the SNMP write community, you

can both access and change SNMP information.

• In the System Contact and System Location fields, enter a contact name and the wiring

closet, floor, or building where the switch is located.

(Optional) You can enable IPv6 on the switch in the Advanced Settings screen. In the Enable

Step 17

IPv6 field, click Enable to enable IPv6 on the switch. Note: Enabling IPv6 restarts the switch

when you complete Express Setup.

Table of Contents

Catalyst 3750-e