Using The Switch Ethernet Management Port; Other Management Options - Cisco Catalyst 3750E-48PD-F Getting Started Manual

Cisco systems hub/switch getting started guide

Hide thumbs Also See for Cisco Catalyst 3750E-48PD-F:

Table of Contents

Using the switch Ethernet management port:

Follow these steps:

1. Connect a Category 5 Ethernet cable to the PC Ethernet port. Connect the other end of the cable

to the Ethernet management port on the switch rear panel.

2. Start a Telnet session on the PC.

3. Enter the switch IP address that you assigned by using Express Setup.

4. Use the CLI to enter commands to configure the switch. See the software configuration guide and

the command reference for more information.

You can use SNMP management applications such as CiscoWorks Small Network Management

Solution (SNMS) and HP OpenView to configure and manage the switch. You also can manage it

from an SNMP-compatible workstation that is running platforms such as HP OpenView or

SunNet Manager.

The Cisco IE2100 Series Configuration Registrar is a network management device that works with

embedded Cisco Networking Services (CNS) agents in the switch software. You can use IE2100 to

automate initial configurations and configuration updates on the switch.

See the "Accessing Help Online" section on page 23 for a list of supporting documentation.

Table of Contents

Catalyst 3750-e