Cisco CATALYST 2960 Hardware Installation Manual page 63
Cisco systems switch user manual
Hide thumbs
Also See for CATALYST 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages)
Table of Contents
Advertisement
Chapter 3
Switch Installation (8-Port Switches)
Figure 3-3
1
Desk or shelf
2
Screw template
Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the three screw
Step 4
template slots.
Insert three screws in the slots on the screw template, and tighten until they touch the top of the screw
Step 5
template.
Remove the screw template from underneath the desk or shelf.
Step 6
Place the switch onto the mounting screws, and slide the switch forward until it locks in place, as shown
Step 7
in
Figure
Note
OL-7075-09
Installing the Mounting Screws Under a Desk or Shelf
1
2
3
3
Screws
4
Adhesive
3-4.
We strongly recommend that you allow at least 3 inches (7.6 cm) of clearance around the
ventilation openings to prevent airflow restriction and overheating.
4
3
Catalyst 2960 Switch Hardware Installation Guide
Installing the Switch
3-9
Hide quick links:
Advertisement
Chapters
Table of Contents
