Installing The Switch; Rack-Mounting - Cisco CATALYST 2960 Hardware Installation Manual
Cisco systems switch user manual
Hide thumbs
Also See for CATALYST 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages)
Table of Contents
Advertisement
Installing the Switch
Attach only the following Cisco RPS model to the RPS receptacle:
Warning
PWR-RPS2300, PWR675-AC-RPS-N1=. Statement 370
As the switch powers on, it begins the POST, a series of tests that runs automatically to ensure that the
switch functions properly. LEDs can blink during the test. POST lasts approximately 1 minute. When
the switch begins POST, the System, RPS, Status, Duplex, and Speed LEDs turn green. The System LED
blinks green, and the other LEDs remain solid green.
When the POST completes successfully, the System LED remains green. The RPS LED remains green
for some time and then reflects the switch operating status. The other LEDs turn off and then reflect the
switch operating status. If a switch fails POST, the System LED turns amber.
POST failures are usually fatal. Call Cisco technical support representative if your switch fails POST.
After a successful POST, disconnect the power cord from the switch. Install the switch in a rack, on a
wall, on a table, or on a shelf as described in the
Installing the Switch
This section applies to all switches except the Catalyst 8-port switches. For information applicable to
those switches, see
This section describes these installation procedures:
•
•
•
Rack-Mounting
This section applies to all switches except the Catalyst 8-port switches. For information applicable to
those switches, see
might not show your specific switch; however, the instructions apply to all 24- and 48-port switches.
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
Warning
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
•
•
•
Catalyst 2960 Switch Hardware Installation Guide
2-6
Chapter 3, "Switch Installation (8-Port Switches)."
Rack-Mounting, page 2-6
Wall-Mounting, page 2-11
Table- or Shelf-Mounting, page 2-14
Chapter 3, "Switch Installation (8-Port Switches)."
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in
Statement 1006
the rack.
Chapter 2
Switch Installation (24- and 48-Port Switches)
"Installing the Switch" section on page
The illustrations in this section
2-6.
OL-7075-09
Hide quick links:
Advertisement
Chapters
Table of Contents
