Enabling Or Disabling Igmp Snooping; Cli: Enabling Or Disabling Igmp Snooping - Cisco Catalyst 2950 Software Manual
Desktop switch software configuration guide
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (674 pages)
Table of Contents
Advertisement
Understanding and Configuring IGMP Snooping
Layer 2 multicast groups learned through IGMP snooping are dynamic. However, you can statically
configure MAC multicast groups by using the ip igmp snooping vlan static command. If you specify
group membership for a multicast group address statically, your setting supersedes any automatic
manipulation by IGMP snooping. Multicast group membership lists can consist of both user-defined and
IGMP snooping-learned settings.
Catalyst 2950 switches support a maximum of 255 IP multicast groups and support both IGMP version
1 and IGMP version 2.
If a port spanning-tree, a port group, or a VLAN ID change occurs, the IGMP snooping-learned multicast
groups from this port on the VLAN are deleted.
In the IP multicast-source-only environment, the switch learns the IP multicast group from the IP
multicast data stream and only forwards traffic to the multicast router ports.
Enabling or Disabling IGMP Snooping
By default, IGMP snooping is globally enabled on the switch. When globally enabled or disabled, it is
also enabled or disabled in all existing VLAN interfaces. By default, IGMP snooping is enabled on all
VLANs, but it can be enabled and disabled on a per-VLAN basis.
Global IGMP snooping overrides the per-VLAN IGMP snooping capability. If global snooping is
disabled, you cannot enable VLAN snooping. If global snooping is enabled, you can enable or disable
snooping on a VLAN basis.
CLI: Enabling or Disabling IGMP Snooping
Beginning in privileged EXEC mode, follow these steps to globally enable IGMP snooping on the
switch:
Command
Step 1
configure terminal
Step 2
ip igmp snooping
Step 3
end
Step 4
show ip igmp snooping
Step 5
copy running-config startup-config
To globally disable IGMP snooping on all VLAN interfaces, use the no ip igmp snooping global
command.
Beginning in privileged EXEC mode, follow these steps to enable IGMP snooping on a VLAN interface:
Command
Step 1
configure terminal
Step 2
ip igmp snooping vlan vlan-id
Step 3
end
Catalyst 2950 Desktop Switch Software Configuration Guide
11-2
Purpose
Enter global configuration mode.
Globally enable IGMP snooping in all existing VLAN interfaces.
Return to privileged EXEC mode.
Display snooping configuration.
(Optional) Save your configuration to the startup configuration.
Purpose
Enter global configuration mode.
Enable IGMP snooping on the VLAN interface.
Return to privileged EXEC mode.
Chapter 11
Configuring IGMP Snooping and MVR
78-11380-03
- Quick Links:
- Features
- Basic Ip Connectivity to the Switch
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
