Console And Auxiliary Port Cable Connections; Connect The Router To The Network - Cisco ASR 1004 Quick Start Manual
Cisco systems router user manual
Hide thumbs
Also See for ASR 1004:
- Install manual (32 pages) ,
- Hardware installation manual (188 pages) ,
- Software configuration manual (462 pages)
Table of Contents
Advertisement
Step 5
Locate the chassis ground connector on the side of your chassis.
Insert the two screws through the holes in the grounding lug.
Step 6
Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held firmly to the
Step 7
chassis. Do not overtighten the screws.
Step 8
Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an adequate
chassis ground.
This completes the procedure for attaching a chassis ground connection. Go to the
on page 12
for information on attaching cables.
4
Connect the Router to the Network
This section provides information about cables and ports and attaching the router to the network.
•
Console and Auxiliary Port Cable Connections, page 12
Management Ethernet Port Cable Connection, page 13
•
Connect the Shared Port Adapter Cables, page 14
•
Install Cables in the Cable-Management Bracket, page 14
•
Console and Auxiliary Port Cable Connections
This section describes how to attach a cable to the console or auxiliary ports on the Cisco ASR 1004 Router.
Router uses RJ-45 ports for both the auxiliary port and console port to attach a modem or console terminal.
The console DCE-mode port connects a console terminal and a DTE-mode auxiliary port connects a modem or other DCE device
to your router.
Note
Both the console and the auxiliary ports are asynchronous serial ports; any devices connected to these ports must be
capable of asynchronous transmission. (Asynchronous is the most common type of serial device; for example, most
modems are asynchronous devices.)
Before connecting a terminal to the console port, configure the terminal to match the router console port as follows:
Step 1
9600 baud, 8 data bits, no parity, 1 stop bits.
Figure 8
Cisco ASR1000 Route Processor Console and Auxiliary Port Connectors
CON—console port
1
12
-PO S
SPA -4X OC3
-PO S
SPA -4X OC3
HD
CA RR IER
US B
CR IT
DF
MA J
ACT V
PW R
DIS K
1
MIN
STB Y
0
STA T
AS R1 00 0-R
P1
AUX —auxiliary port
2
"Connect the Router to the Network" section
1
2
-PO S
SPA -4X OC3
AUX
LIN K
CO N
ERN ET
MGM T ETH
BIT S
The Cisco ASR1004
- Quick Links:
- Configure the Router
Hide quick links:
Advertisement
Table of Contents
