Table of Contents
Advertisement
REAR AXLE/FINAL DRIVE ASSEMBLY AND DRIVE
SHAFT
EBS00397
INSTALLING THE NUTS
1. Tighten:
• nuts 1, 2
M
MMM
M MMM
M
M MMM
a. Check if the rear brake assembly is installed
on the rear axle housing. If the rear brake
assembly is not installed, refer to "FRONT
AND REAR BRAKES" in chapter 7 for
installation instructions.
NOTE:
Before tightening the nuts, apply the LOC-
®
TITE
to the thread portion of the rear axle.
b. Finger tighten the inside nut 1 while check-
ing the ring gear engagement.
c. Tighten the inside nut with rear axle nut
wrench to specification while holding the
rear axle.
Axle nut wrench (36 mm)
P/N. YM-37132, 90890-01422
Inside nut (first tightening)
110 Nm (11.0 m · kg, 80 ft · lb)
d. Hold the inside nut 1 and tighten the out-
side nut 2 with the rear axle nut wrench to
specification.
Outside nut
130 Nm (13.0 m · kg, 94 ft · lb)
e. Draw a line a on the inside and outside nut.
f. Hold the outside nut 2 and tighten back the
inside nut 1 with the rear axle nut wrench
to specification.
Inside nut (final tightening)
160 Nm (16.0 m · kg, 115 ft · lb)
g. Measure the distance b between the lines.
If distance b is less then 3 mm (0.12 in),
retighten back the inside nut.
L
LLL
L LLL
L
L LLL
6 - 13
DRIV
M
M MMM
M
M MMM
M
L
L LLL
L
L LLL
L
M MMM
M
MMM
L LLL
L
LLL
- Quick Links:
- Electrical
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
