Table of Contents
Advertisement
Caution
Caution
Removing the DFC
Note
Throughout this publication, unless otherwise noted, the term DFC refers to the DFC, DFC3A, DFC3B,
and DFC3BXL.
Note
The figures in this procedure show the DFC. The procedure is the same for the DFC, DFC3A, DFC3B,
and DFC3BXL.
During this procedure, wear grounding wrist straps to avoid ESD damage to the module. Do not directly
Caution
touch the backplane with your hand or any metal tool, or you could shock yourself.
To remove the DFC, perform these steps:
Remove the module from the Catalyst 6500 series switch. (Refer to the Catalyst 6500 Series Switch
Step 1
Module Installation and Verification Note for removal instructions.)
Place the module on an antistatic mat or foam, with the front of the module facing toward you.
Step 2
Use a Phillips-head screwdriver to remove the securing screws and the two cap nuts from the DFC.
Step 3
(See
78-11627-04
Use care not to damage the connectors on the module. If you damage a connector, it will be
necessary to return the module to Cisco for repair.
You must install screws in all available standoffs. The screws provide grounding between the
DFC3 and the module. Failure to install all screws will invalidate the safety approvals and
pose a risk of fire and electrical hazard.
Figure
1.)
Catalyst 6500 Series DFC, DFC3A, DFC3B, and DFC3BXL Installation Note
Removing the DFC
9
Advertisement
Table of Contents
