HP 610 Setup Poster
Digital copier series
Hide thumbs
Also See for 610:
- Reference manual (102 pages) ,
- Printing manual (48 pages) ,
- Quickspecs (34 pages)
Advertisement
Quick Links
hp 510/610 digital copier series
setup poster
1
Install the two-sided printing accessory
(hp 610 digital copier only)
a.
b.
3
Back view of unit
4
Connect the power
3
1
2
7
Insert the printheads
Lift the door (beneath the front
1
panel) until it locks into place.
a.
Make sure you
remove any
packaging from
inside the unit.
b.
8
Insert ink cartridges
Unwrap the ink
1
cartridges. Hold
each cartridge
away from you, as
you remove the
tape. Do not touch
the copper
Hold the ink
contacts.
cartridge away from
clothing. Ink may
The automatic document
feeder tray and the two-
sided printing accessory
may be included.
2
Install the automatic document feeder (ADF) tray
(hp 610 digital copier only)
Make sure the tray
snaps into place.
5
Turn the hp digital copier on
Release the gray print carriage
2
latch, and then lift the print carriage
to access the printhead carriage.
a.
gray print
carriage latch
b.
b.
a.
Insert the black ink
2
cartridge into the left
side of the print
carriage. Insert the tri-
color ink cartridge on
the right side. Make
sure the cartridges are
seated.
Close the door.
3
You must install the main paper tray and
load plain white paper
3
2
6
Set the country and language
ABC
DEF
GHI
JKL
PQRS
Unwrap and remove the tape from
3
4
each printhead.
Do not touch the copper contacts.
a.
a.
b.
Push the printhead handles down.
Do not touch the
b.
copper contacts.
Do not touch
the tower.
9
Align the printheads
Press the Enter button to begin
alignment. After a page prints with
checkmarks, alignment is complete.
If page is blank, see the reference
guide for troubleshooting. Discard or
recycle this page.
Leave the unit on for an additional ten
minutes to finish charging. You may
continue to the next step.
Look at the display. Use the arrow keys to scroll through the language list. Enter
1
the code for your language on the keypad, and then confirm your selection. If you
make a mistake, see the reference guide.
2
Enter the code for your country, and then confirm your selection.
Install each of the four printheads. Match
5
the color on the top of the printhead to the
color on the printhead carriage.
For future reference: Do
not remove printheads
until you are ready to
replace them.
10
Try your new hp digital copier
Look in the reference
guide for information on
how to get started using
your hp digital copier.
Move the print carriage latch
down and make sure the loops
catch the hooks. Snap the latch
into place.
Advertisement
