Connecting The Power; Connecting Your Phone To The Network; Connecting Your Phone To The Wired Network - Cisco SPA525G User Manual
Cisco ip phone user guide
Hide thumbs
Also See for SPA525G:
- Quick start manual ,
- User manual (117 pages) ,
- Setup and user manual (19 pages)
Table of Contents
Advertisement
Installing Your Phone
Connecting the Power
Connecting the Power
Connecting Your Phone to the Network
STEP 1
STEP 2
NOTE
Cisco SPA525G and Cisco SPA525G2 SIP IP Phone User Guide
The Cisco SPA525G and Cisco SPA525G2 do not ship with power supplies. If you
are not using Power over Ethernet (PoE), you must order a Cisco PA100 power
adapter for each phone.
If you are using Power over Ethernet (PoE) to power the phone, the phone receives
power when you connect an Ethernet cable from the phone SW port to a switch
that provides PoE. See the
section on page
26. If you are using a Cisco PA100 power adapter, insert one end
of the power adapter into an outlet and insert the other end into the power port on
the phone body.
The phone can be connected to a wired or wireless network by using a Cat5
(Cat5e or higher for the Cisco SPA512G and Cisco SPA514G) Ethernet cable, or
through a wireless network connection.
Connecting Your Phone to the Wired Network
You connect your phone to the local network by using an Ethernet cable:
Plug the Ethernet cable into the back of the base station into the slot marked "SW."
This port is labeled #4 on
Plug the other end of the Ethernet cable into the appropriate device on your
network, such as a network switch.
The Cisco SPA525G and Cisco SPA525G2 provides a second Ethernet port. You
can connect a PC to this port to provide network access to the PC. This port is
labeled #4 in
Figure
1.
the network by using the built-in Wireless-G client.
"Connecting Your Phone to the Wired Network"
Figure 1 on page
This port cannot be used when the phone is connected to
23.
2
26
Hide quick links:
Advertisement
Table of Contents
