Table of Contents
Advertisement
b. Note: Your MR20-HW must have an active route to the Internet to check
and upgrade its firmware.
2. Verify access point connectivity
a. Use any 802.11 client device to connect to the MR20-HW and verify proper
connectivity using the client's web browser.
3. Check network coverage
4. Confirm that you have good signal strength throughout your coverage area. You
can use the signal strength meter on a laptop, smart phone, or other wireless
device.
Troubleshooting
Reference the
MR Product Page
Regulatory
This equipment is for indoor use only and the PoE device is considered unlikely to
connect to an Ethernet network with outside plant routing, including campus
environments.
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
for additional information and troubleshooting tips.
Advertisement
Table of Contents
