Table of Contents
Advertisement
Using two pairs of front speakers (SPEAKERS A/B)
If you connect two pairs of front speakers to the CH.3 A/B terminals, you can switch the front
speakers to be used by pressing SPEAKERS A/B on the front panel of the unit.
• When using two pairs of the speakers connected to the CH.3 A/B terminals at the same time, be sure to use 8-ohm
speakers and set IMPEDANCE SELECTOR to the upper position (p.15).
BRIDGE
A
CH.3 A/B (R)
(
)
CH.3
terminals
FRONT
B
20
Advanced speaker configuration
En
The unit (rear)
BRIDGE
A
(
)
CH.3
FRONT
B
Using three speakers for one channel (multi-speaker)
If you want to use three speakers for reproducing CH.1 audio signals (such as center channel
signals), change the CH. SELECTOR setting and connect the speakers to the CH.1 and CH.2 (L/R)
terminals.
CH.3 A/B (L)
terminals
CH.2 (R)
terminal
CH.1
terminal
Input from pre-amplifier
CH.1
CENTER
Set CH. SELECTOR for
CH.2 (R) and CH.2 (L)
CH.2 AMP ASSIGN
CH.2 AMP ASSIGN
CH.1
CH.1
to "CH.1"
CH.2
CH.2
CH.2
SURROUND
BACK
The unit (rear)
CH.1
CENTER
CH.2 (L)
CH.2
terminal
SURROUND
BACK
Advertisement
Table of Contents
