Table of Contents
Advertisement
Available languages
Available languages
USE & OPERATION (CONTINUED)
FILLING WITH WATER (CONTINUED)
The Water Level Indicator is located at the back of the unit. Refill the water tank when water level
is low. Do not fill water above the "Max." water level mark to avoid water droplets collecting on the
louvers. Check the water level in the tank before running the COOL function. Make sure there is water
in the tank by using the continuous water supply connection or by filling the tank up to the maximum
indicator level. Running the unit in COOL mode with inadequate water may cause pump failure.
Note: The water capacity refers to the total volume of water that can be contained within the air
cooler water tank and water distribution system. The water capacity in the tank at the "Max." indicator
level may be lower than the actual water capacity of the air cooler.
WARNING: Do not fill water tank with dirty water or salt water. This can damage the unit and
Honeycomb media.
CLEANING & DRAINING THE WATER TANK
Below are instructions on how to clean and maintain your air cooler. If the cooler will not be used
for a long period of time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in
the separate Safety & Maintenance Guide.
WARNING:
Before cleaning the unit, power OFF the unit and disconnect from the electrical socket.
• Move the unit to a location where the water can be drained. Remove the cap from the drain plug
located at the bottom of the unit. Allow the tank to empty.
• Refill the water tank with clean water, up to the maximum level and drain it completely.
• Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive
elements or chemicals to clean this product.
• When the product is not in use, store the unit in a dry place out of direct sunlight.
EN
5
Advertisement
Table of Contents
