Table of Contents
Advertisement
SC-F10000H Series/SC-F10000 Series
I
While pressing from the top of the media holder,
tighten the fixing screw.
Tighten it so the media holder does not move.
J
Rotate the handle until part A in the illustration
below is fully inserted.
c
Important:
Once part A is hidden, do not turn the handle
any further. Failure to observe this precaution
could damage the media holder.
If part A is still visible even after the handle has
been turned fully, rewind the handle. Loosen
the media holder screw on the right side, and
then restart from Step 5.
User's Guide
Basic Operations
K
Next, see the following according to the procedure.
Normal feeding procedure U
Normal Feeding Procedure" on page 81
Take-up feeding procedure U
Take-Up Feeding Procedure" on page 83
80
Leave a 10 to 20 cm (3.93 to 7.87 in.) wide section
in the center of the media, and cut at least 25 cm
(9.84 in.) in height from the left and right corners
of the media.
Cutting the media prevents feeding problems,
such as the left and right corners of media being
folded and caught at the start of take-up.
"Take-up with the
"Take-up with the
Advertisement
Table of Contents
