Advertisement
Quick Links
Advertisement
Related Manuals for Whirlpool IFW Series
Summary of Contents for Whirlpool IFW Series
- Page 1 IFW Series Error Code List and Diagnostic Codes...
- Page 2 Error Code Description Where to Check How to resolve the problem The washer does • Check if the Power Cord is securely plugged in. • Press the POWER ON/OFF button. not work at all • Press the PRESET button • Check whether power failure occurs. •...
- Page 3 Error Code Root Cause Error Error Code Root Cause Error When the bubble finally detected excessive When heated ,the heater did not work properly dehydration or the load is too large, after adjustment E901 When no heating , It detects abnormal water heating still detects excessive foam or the load is too large;...
- Page 4 Does the inlet valve vibrate during filling cycle? Water does not Is the faucet turned on? Turn the faucet on flow into the Wash/Spin Tub or water flow is very Clean the inlet valve or Is the valve assembly little. the metal filter blocked? Arrange the wiring...
- Page 5 Is the drainage outlet of the user's home Clean blocked? Is that blocked at the drain pipe? Is the drainage pipe Is there the foreign matter Washer is not Smooth? in the drain system？ draining Is the yellow 3 chip power Clear out the drain pipe terminal of the control circuit system...
- Page 6 Replace display board Replace the water level The water level sensor's sensor damage is few Abnormal condition of water level sensor...
- Page 7 HOW TO LAUNCH THE DIAGNOSTIC TEST Hold “ Delay Start” Push “ Power” Push “ Start/Pause” three times ( 100ms interval) Push : “Delay Start “ Push “ Express wash” Push “ Rinse” Push “ Temp” Push ”Spin Speed” Push “ Start/Pause” 10.
- Page 9 HOW TO LAUNCH THE SERVICE DIAGNOSTIC TEST Hold “ Rinse” Push “ Power “ Push “ Start/Pause” three times ( 100ms interval) Push “ Delay Start “ until “ 00 “ Push “Express Wash “ to show “01” Push “Start” Drum rotate CCW &...
- Page 11 HOW TO FORCE WATER FILL Hold “ Rinse” Push “ Power “ Push “ Start/Pause” three times ( 100ms interval) Push “ Delay Start “ until “ 00 “ Turn the knob to “Down” Press Start...