Table of Contents
Advertisement
CAUTION:
Do not place any object on top of a rack-mounted device unless that rack-mounted device is
intended for use as a shelf. (R008)
(L012)
CAUTION: Pinch hazard. (L012)
7. Remove the service access cover. For instructions, see "Removing the service access cover from an
8001-12C or 8005-12N system" on page 80.
Preparing the 8001-12C or 8005-12N system for operation after you
remove and replace internal parts
Learn how to prepare the IBM Power System S821LC (8001-12C) or the IBM CS821 (8005-12N) system for
operation after you remove and replace internal parts.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Replace the service access cover. For instructions, see "Installing the service access cover on an
8001-12C or 8005-12N system" on page 81.
3. Place the system into the operating position. For instructions, see "Placing an 8001-12C system into
the operating position" on page 84.
(L012)
CAUTION: Pinch hazard. (L012)
4. Reconnect the power cords to the system. For instructions, see "Connecting the power cords to an
8001-12C, 8001-22C, 8005-12N, or 8005-22N system" on page 86.
5. Start the system. For instructions, see "Connecting the power cords to an 8001-12C, 8001-22C,
8005-12N, or 8005-22N system" on page 86.
6. If you installed or replaced a PCIe adapter, update the adapter firmware. See http://www.ibm.com/
support/knowledgecenter/HW4P4/p8ei8/p8ei8_update_other_adapter.htm(www.ibm.com/support/
knowledgecenter/HW4P4/p8ei8/p8ei8_update_other_adapter.htm).
7. Verify the installed part. For instructions, see Verifying a repair (www.ibm.com/support/
knowledgecenter/POWER8//p8ei3/p8ei3_verifyrepair.htm).
72
Power Systems: Servicing the IBM Power System S821LC (8001-12C) or the IBM CS821 (8005-12N)
or
or
Advertisement
Table of Contents
