Cisco Nexus 9332PQ Hardware Installation Manual page 33

Nx-os-mode switch

Hide thumbs Also See for Nexus 9332PQ:

Table of Contents

Installing the Switch Chassis

4 Place the power cable positive-wire terminal ring on the positive terminal for the power source and secure

them with a terminal nut.

5 Place the power cable ground-wire terminal ring on the ground terminal for the power source and secure

them with a terminal nut.

6 Turn on the power at the power source circuit breaker.

Step 4

Verify that the power supply

Step 5

Listen for the fans; they should begin operating when the power supply is powered.

Step 6

After the switch boots, verify that the following LEDs are lit:

• On the fan modules, the Status (STA or STS) LED is green.

If a fan module Status LED is not green, try reinstalling the fan module as described in

on page

31.

• After initialization, the switch chassis Status (labeled as STA or STS) LED is green.

• The Link LEDs for the Ethernet connectors are lit if connected to interface cables.

Step 7

Verify that the system software has booted and the switch has initialized without error messages.

Step 8

Complete the worksheets provided in

Note

A setup utility automatically launches the first time that you access the switch and guides you through the basic

configuration. For instructions on how to configure the switch and check module connectivity, see the appropriate Cisco

Nexus 93xxx configuration guide.

LED is on and green.

Site Preparation and Maintenance Records

Cisco Nexus 9332PQ NX-OS-Mode Switch Hardware Installation Guide

Starting the Switch

Replacing a Fan Module,

for future reference.

Table of Contents